Magmaweld MONOSTICK 200 PFC User Manual - page 7
6
MONOSTICK 200i PFC
2
3
4
5
6
8
1
7
9
Power Switch
Power LED
Thermic / Error LED
Current Adjustment Knob
Earth Cable and Welding Cable Socket (-)
1
2
3
4
5
Earth Cable and Welding Cable Socket (+)
Line Cable Inlet
Handle
Fan
6
7
8
9
Monostick
i
is an inverter type portable, mono-phase DC MMA welding machine designed to weld
stick electrodes up to 4 mm. Even though the machine is mono-phase, due to the inverter technology it
provides stable arc and good re-striking performance
the electric consumption
is approximatel
This unit can also be used as a DC TIG power source for touch-start applications.
Monostick
0i
proved well that it can work between 160 to 240 V 50/60 Hz line voltages. Therefore this
machine is quite immune to mains voltage fluctuations and perfectly welds with generator-sets.
Monostick
0i
can also be used with long welding cables up to 25 mt.
The machine is fan cooled and thermally protected against over heating.
200 PFC
. Thanks to its PFC technology,
y 40% less than the inverters without PFC and the magnetically controlled equipments. It does
the same work with less energy, therefore you bring down the energy costs and you help protecting the
environment. Another advantage of PFC technology is to provide working without efficiency loss when you
work with long cables.
*
20 PFC
20 PFC
PFC is the technology which is used for filtering harmonic currents of welding inverters. Thanks to PFC, input
power decreases and that directly effects the electric bill and provides environment protection with energy
efficiency. No performance loss occurs due to voltage fluctations. No performance loss occurs while
operating with long power cables.
What is PFC Technology?
(*) For more information about TIG welding, check page 9.
TECHNICAL INFORMATION
1.2 COMPONENTS OF THE MACHINE
1. TECHNICAL INFORMATION
1.1 GENERAL EXPLANATIONS
Figure 1: Components of Monostick 200i PFC