Magmaweld RS 200 MK User Manual - page 10
2. INSTALLATION
INSTALLATION
2.1 UPON RECEIPT AND CLAIMS
ú
ú
ú
ú
Standard pallet contains:
Power Source
Earth Cable
Gas Hose
User Manual
2.2 INSTALLATION AND WORKING RECOMMENDATIONS
• Use lifting eyes or fork-lift to carry the machine. DO
NOT lift the machine together with the gas cylinder.
Transport and place the device on a firm and level
ground so that it may not fall over. The maximum
permissible angle of inclination for transport and
assembly is 10°.
• For a better performance, keep the machine at
least 30 cm away from the surrounding objects.
Beware of excessive heat, dust and humidity
around the machine. Try not to operate the
machine under direct sunlight. Machines should
be operated on lower capacities when ambient air
temperature exceeds 40ºC.
• Avoid welding at outdoors where it is windy and
rainy, if this is a must, protect the welding area with
curtains, mobile screens or tents.
• Ensure that operators can easily reach the
machine controls and connections.
• Use suitable welding fume extraction systems.
Use breathing apparatus if there is a risk of inhaling
in confined places.
Respect the duty cycles given at the
data plate. Exceeding the duty cycles
frequently can damage the machine and
this would void the warranty.
• Do not use stronger fuses than those
stated on the data plate.
• Ensure that the earth clamp is tightly
connected as close as possible to the
welding location. Do not let welding
current flow through any media other
than welding cables; e.g. over the
machine itself, gas tubes, chains, ball
bearings, etc.
When the gas cylinder is placed on the machine,
immediately lock the chain to secure the cylinder,
otherwise, the stand alone cylinders should also be
secured to a wall by chains.
• The electrical socket behind the machine is for CO
heater, it is not recommended to connect other
devices.
2
2.3 ELECTRIC PLUG CONNECTION
Since mains connection sockets may vary from
factory to factory, an appropriate plug must be
installed to the built-in mains cable of the machine
by qualified electricians. Please observe that the
earth cable is in yellow/green colour and labeled
as
. After installing the electric plug, DO NOT
INSERT IT INTO THE SOCKETAT THIS STAGE.
Figure 3: Electric Plug Connection
Be sure that you have received all the items that
you have ordered. In case of any item is missing or
damaged, contact your supplier immediately.
In the event of damaged or missing delivery,
it to the shipping agency and MAGMA
MEKATRONIK with the photocopy of shipping bill.
E-mail: servis@magma.com.tr
Fax: +90 236 226 27 28
draw
up a record, take a photo of the damage and
report
RS 200 MK / RS 300 MK / RS 400 MK
9