Magmaweld RS 200 MK User Manual - page 12
RS 200 MK / RS 300 MK / RS 400 MK
11
Before plugging your machine to the
electrical line check with a voltmeter the correct
voltages indicated at the plate of the machine and
then insert the plug into the socket.
SWITCH ON the machine via power switch
.
Observe the fan noise and illumination of the V/A
digital meters
.
(1)
(5-6)
While inserting the plug
into the socket, pay
attention that main
switch is positioned to
“0”.
Figure 7: Mains Connection
3.2 CHOOSING AND CHANGING THE LINER
3.3 CONNECTING THE TORCH
Nozzle
Contact Tip
Adapter
Figure 8: Removing the Nozzle, the Contact Tip and the Adapter
Nut of Liner
Liner
Figure 9: Removing the Liner and Installing the New Liner
Figure 10: Cutting off the Liner Stick Out and Reassembling the Torch
Check if the liner and the contact tip is matching
with the diameter of the welding wire. If it is
needed, change the liner and the contact tip.
To change the liner; remove the nozzle, the
contact tip and the adaptor respectively
(Figure 8).
Unscrew the liner's nut which is on torch connector
side and remove the liner existing in torch. After
inserting the new liner into the torch, screw its nut
tightly (Figure 9).
Cut off the stick out of the liner with a side cutter. Be
sure that head of the liner is smooth.
Reassemble the adaptor, the contact tip and the
nozzle respectively with help of an appropriate
hand tool (Figure 10).
Liner
Stickout
3.
OPERATION
OPERATION
3.1 CONNECTING TO THE MAINS
0
1
2
3
4
Insert the torch into the torch connector
and
screw its nut tightly.
(8)
Figure 11: Connecting the Torch
Nut of Torch