Magnasonic FS50 User Manual - page 4
6
7
Guide
Menu
Capture Picture
1.
Before scanning please make sure the inner backlight panel is clean.
Note:
You can use the provided brush to clean the screen.
Install The negative method
1.
Hold up the slide toward
the light.
2.
Face the right side of the
slide to yourself.
3.
Take the slide holder out.
4.
Let the side with “OPEN”
logo face yourself, and let the
side with “ ”logo face down.
5.
Open the slide holder, then
place slides into the holder
(film can also be loaded as a
strip into the slide holder).
6.
Close the slide holder and
press the edges so that it
locks in place.
7.
Insert the slide holder into
the slot on the right side of
the film scanner as shown.
Handle films with care to avoid scratches or finger prints(for the best results
use cotton gloves when handling films) It is recommended to use compressed cotton
to remove any dust on the films.