Magnavox MD6972 Owner's Manual - Operation
8
RADIO:
1. Slide the Function Selector to RADIO position to turn on the radio.
2. Press the
/BAND Button repeatedly to select AM or FM band as desire. The correspondence
indicator AM or FM and the radio frequency will appear on the LCD Display.
3. Press and holding the or Buttons until the radio frequency on the LCD Display start
running to automatically search and play the previous/next available radio station. Repeated the
same procedures until the desired radio station is searched and play.
4. If the reception is no good, turn the FINE TUNE Knob to fine tune.
5. Turn the VOLUME Control Knob to adjust volume level as desire.
6. When finished listening, slide the Function Selector to OFF position to power of the unit.
Radio stations preset:
1. Power on the radio and receive the desired radio station as the previously procedure.
2. Press the M Button, "P XX" will appear on the LCD Display. Press the or Buttons
repeatedly to select the program number you want stored to. Then press the M Button again to
store it.
3. Repeat the same procedures until all the desired radio stations were stored into the program list.
(Up to 20 AM stations and 30 FM stations can be stored.)
4. After programmed, press the or Buttons repeatedly in radio mode to select and play the
desired stored radio station.
Antennas:
AM:
This unit has a built-in ferrite rod antenna, which provides adequate reception in most areas. If
reception is weak, turn the unit to improve reception.
FM:
The FM Telescopic Antenna is for FM reception only. If reception is weak, adjust the length and the
angle of the antenna.
CD:
1. Slide the Function Selector to BT/CD/AUX position to turn on the CD. The LCD Display will
illuminate and indicator “CD” will appear.
2. Press the OPEN/CLOSE Area on the CD Door to open it then place a CD disc on the center
spindle, with the printed side face up.