Magnavox MME-110 User Manual - page 16
16
English
8240 009 34241
Radio Reception
STANDBY-ON
TAPE
DYNAMIC BASS BOOST
CD
TUNER
AUX
PROGRAM
REPEAT/
SLEEP
DSC
PLAY•PAUSE
VOLUME
DBB
DIGITAL
SOUND
CONTROL
Tuning to radio stations
1
Select TUNER source.
2
Press TUNER again (or BAND on the remote
control) to select the desired waveband : FM or
AM.
3
Press and hold down on
S or T (à or
á) until the frequency indication starts to
change, then release.
➜ The display will show "
Src" until a radio
station with sufficient signal strength is found.
4
Repeat step 3 if necessary until you find the
desired station.
● To tune to a weak station, press
S or T
(à or á) briefly and repeatedly until you have
found optimal reception.
Programming radio stations
You can store up to a total of 15 radio stations
for both FM and AM bands in the memory.
Manual programming
1
Tune to your desired station (refer to “Tuning to
radio stations”).
2
Press PROGRAM to activate programming.
➜
PROG
flashes in the display.
3
Press
S or T ( ¡ or ™) briefly and
repeatedly to assign a number from 1 to 15 to
this station.
4
Press PROGRAM again to confirm the setting.
➜
PROG
disappears, the system will resume to
the last tuned radio station.
5
Repeat the above four steps to store other
stations.
● You can override a preset station by storing
another frequency in its place.
Note:
– During programming, if no button is pressed
within 15 seconds, the system will exit the program
mode automatically.
Tuning to preset radio stations
● Press
¡ or ™ on the remote control briefly and
repeatedly until the desired preset station is
displayed.
pg 001-024/MME110/37-Eng
6/3/02, 12:50 PM
16