Magnetrol Jupiter JM4 Installation And Operating Manual - page 9
16
ORI-46.650 Jupiter Magnetostrictive Transmitters
ORI-46.650 Jupiter Magnetostrictive Transmitters
17
The Home Screen presentation can be customized by viewing or
hiding some of these items. See DISPLAY CONFIG under the
DEVICE SETUP menu in Section 1.6.4 HART Menu - Model
JM4.
Figure 1-9 is an example of a Home Screen for a Model JM4
configured for a Level Only application.
MAIN MENU
Pressing any key on the Home Screen will present the Main
Menu, consisting of three basic menu labels shown in all capital
letters.
•
DEVICE SETUP
•
DIAGNOSTICS
•
MEASURED VALUES
As shown, the reverse video represents a cursor identifying the
selected item, which will appear in reverse video on the LCD. The
actions of the keys at this point are:
Push Button
KeystrokeAction
Up
Noaction,asthecursorisalreadyatthefirstitemin
the MAIN MENU
Down Moves the cursor to DIAGNOSTICS
Back Moves back to HOME SCREEN, the level above
MAIN MENU
Enter Presents the selected item, DEVICE SETUP
NOTES: 1. Items and parameters that are shown in lower level menus
willdependontheMeasurementTypechosen.Thoseparam-
etersnotapplicabletothepresentMeasurementTypewillbe
hidden.
2.HoldingdowntheEnterkeywhenthecursorishighlighted
over a parameter or menu will provide additional information
about that item.
DEVICE SETUP
Choosing DEVICE SETUP from the MAIN MENU will result
in an LCD presentation as shown at left.
The small down arrow shown at the right hand side of the screen
is the indication that more items are available below and can be
accessed by pressing the DOWN key.
Section 1.6.4 shows the entire tree menu for the Model JM4
DEVICE SETUP Menu.
MEASURED VALUES
Allows the user to scroll through all of the available measured
values for the measurement type chosen.
MAIN MENU
DEVICE SETUP
DIAGNOSTICS
MEASURED VALUES
Hold down Enter key
for help
Fig. 1-12. Main Menu
1.5.5 Auto-Configuration/ResetNewProbeDiagnostic
Each JM4 probe has its own set of configuration parameters
stored inside. With these parameters, it is possible to auto-
configure the transmitter using the following steps.
1. Connect the new probe to the transmitter.
2. The home screen will display a “Device Failure: New Probe”
message in alternating video on the screen.
3. Pressing any key will bring the user directly to the “Clear New
Probe Diagnostic” line in the Device Setup\Advanced Config\
Probe Params menu.
NOTE: Clear New Probe Diagnostic will replace current settings
withthoseneededtoproperlyusethenewlyattached
probe.Beforeexecuting,considersavingafilecontaining
yourcurrentBasicConfig,I/OConfig,andLocalDisplay
ConfigsettingsforreferenceusingtheDTMoraHART
communicator.
4. Press the Enter key to initiate the clearing process.
NOTE: Afterrunningthediagnostic,checkPV,measurementtype,
and 4 and 20 mA set points to be sure these parameters are
appropriatelysetfortheapplication.