Magnum 232 Operator's Manual - page 12
Original Instruction
12 / 17
6. Close the battery door.
Battery condition can be checked at any time by pressing the button on the handle-mounted fuel gauge (item 10 Fig1).
TO REMOVE BATTERY PACK
1. Release the power switch to stop the mower. Remember that it takes a few moments for the blades to stop turning
2. Open the battery door
3. Remove the isolator key.
4. Press and hold the battery latch button at the bottom of the battery pack.
5. Slide the battery pack upwards to remove the battery pack from the mower.
NOTE: We recommend that when the mower is left unattended, both the battery and the isolator key are removed to prevent
accidental starting.
NEVER ATTEMPT ANY MAINTENANCE OR ADJUSTMENT OF THE MOWER UNLESS BOTH THE BATTERY AND
ISOLATOR KEY ARE REMOVED.
STARTING/STOPPING THE MOWER
1. Insert the isolator key into position underneath the slot on the mower.
2. Press and hold the safety switch (step 1), squeeze two of the power switch buttons on horizontal or vertical side (step 2),
and the mower will start.
3. To stop the mower, release the power switch buttons.
For your comfort, four different power switches are provided, two on each side of the handle. You can use any of these
switches – they each have exactly the same function.
ADJUSTING THE UPPER HANDLE HEIGHT
1.Loose the upper handle clamp at each sides.
2.Adjust the handle height to your requirement and fasten the clamps.
1
2
2
1
2
Fuel Gauge