Magnum 232 Operator's Manual - page 13
Original Instruction
13 / 17
ADJUSTING THE CUTTING HEIGHT
Use the cutting height lever (item 7 Fig1) to adjust the cutting height. This single lever will adjust the height of all wheels. There
are five cutting heights to choose from
1.
Pull the cutting height lever sideways and push forwards to increase cutting height and pull backwards to increase
height.
2.
Allow the lever to engage into one of the slots marked 1-5
REPLACING THE CUTTING BLADE
NOTE: Remove the isolate key. Only use genuine replacement blades and parts. Replace worn or damaged blades and bolts
in sets to preserve balance. The part no of blade is 70130040.
1. Loosen the blade nut by turning it counterclockwise.
2. Remove the blade nut, spacer, blade insulator, and blade.
3. Place the new blade on the shaft.
4. Replace the blade insulator and spacer, then thread the blade nut on the shaft and tighten. The blade should end up parallel
with the deck, fitting snugly onto the shaft.
STORING THE MOWER
To lower the handle before storing:
1. Loosen the upper and lower handle fasteners and fold the handles down as illustrated.
2. Avoid pinching or trapping any cables.
15°
du