Magnum P300 Maintenance Manual - page 6
Fit new ladder tape to the edge of the glass ensuring it is centered on the edge of the glass
so that an equal amount of tape will extend down both faces of the glass when it is folded
down. Make sure that the ends of the tape meet tightly at the join. A gap here will allow
air leaks into the firebox and will cause streaking of the glass with soot.
Fit the glass back into the retainer frame, ensuring that the original outer surface of the
glass is again going to be on the outside of the door.
Refit the glass and retainer back into the door frame.
Place the two lugs on the right side of the retainer frame behind the hinge and rotate the
left side back into the door frame to align it with the screw holes. Refit the screws.
Refit the door rope.