Mahlkonig EG43 Operating Instructions Manual - 9. Cleaning The Grinder

L A D E N M Ü H L E N   |   S H O P   G R I N D E R

8. Grind Adjustment Calibration

The grinder has been precisely adjusted by the manufacturer. 

However, if the ground material is no longer fi ne enough after a 

longer period, the grinder must then be re-adjusted according to 

the following procedure:

1.  Turn the rotary knob to position 1 ”fi ne”. Loosen the two 

threaded pins by approx. 1 rotation using the 3 mm hexagon 

spanner enclosed in delivery. The two threaded pins are posi-

tioned in the drilled holes of the rotary knob.

2.  Now switch on the grinder.

3.  Using a screwdriver or coin, carefully turn the large adjust-

ment screw with the slot to the right until you hear a rat-

tling noise (grinding disc are touching). Turn the adjustment 

screw back by approx. 10 degrees and the rattling sound 

should stop. 

4.  If you grind some beans now, you should get fi ne grains (in 

the case of coffee). If the coffee beans have been ground 

too fi ne, the discs can stick together.  The grinder would be 

blocked.

It is important that the rattling sound cannot be 

heard in the fi nest grinding position. Otherwise 

the service life of the grinding discs is reduced 

considerably!

5.  If the adjustment you have made does not come up to your 

expectations you can adjust the grind degree as described 

above.

9. Cleaning the Grinder

Always pull the power supply plug out of the 

outlet before carrying out any maintenance or 

cleaning work on the device!

Observe the safety instructions under 1.2!

Do not let any foreign objects fall into the 

grinding mechanism!!

11