Mahlkonig EG43 Operating Instructions Manual - 6. Operation

L A D E N M Ü H L E N   |   S H O P   G R I N D E R

Determine whether the mains voltage and fre-

quency correspond to the information on the 

rating plate.

Insert the plug into the available grounded outlet.

6. Operation

6.1 How to use the grinder

1.  By moving the rotary knob (pos.3), set the required grind de-

gree (to the left for coarse grind, to the right for fi ner grind).

2. Only 

fi ll whole coffee beans (unground material) into the 

hopper (pos.1). Close the hopper.

3.  Press the handle of the bag holder down (pos.5) and push the 

completely opened bag, which has been smoothed along the 

folds, over the spout. Let go of the handle and the bag is held 

fi rmly in position.

4.  Now you can switch on the grinder (pos.7). 

Knock the base of the bag a number of times whilst grinding. This 

allows the maximum capacity of the bag to be used.

In the case of the combination grinder, by turn-

ing the combined On / Off - selection switch you 

can select the grinder you wish to use. 

You can only grind on the side of the grinder 

casing side you have selected. You cannot grind 

on both sides at the same time.

5.  Once all material has been ground, hold the bottom of the 

bag gently in one hand. Use the other hand to press the han-

dle of the bag holder and allow it to knock against the spout 

2 – 3 times. This removes any ground particles which may 

still be attached to the inside of the spout

6.  Now switch off the grinder (pos. 8) 

7.  Remove the fi lled bag from the spout. The grinding process is 

terminated. Close the main hopper slider.

8