Mahlkonig EG43 Operating Instructions Manual - 10. Maintenance and Repair
L A D E N M Ü H L E N | S H O P G R I N D E R
5. Clean the grinding mechanism with a fi ne brush and remove
any foreign objects.
6 Before pushing the pre-breaker (9) back onto the shaft again,
lubricate the shaft with non-corrosive, resin-free and food-
stuff- compatible grease (e.g. Vaseline).
7. After you have pushed the pre-breaker onto the shaft, line up
the two slots so that you can then easily re-insert carrier (10).
The rounded side of the driver must point to-
wards the motor.
8. Clean the contact surfaces of the grinder casing and grinder
casing cover (12) carefully in order to remove any form of soil-
ing.
During re-assembly, no ground material should
stick to the surfaces where the grinder casing
and the cover touch.
9. Screw down the cover (12) tightly with the two screws (13)
while changing the side several times.
11. Rotate the rotary knob to the desired grind degree. The grind-
er is now ready for operation again.
Poppy seed grinders shall be cleaned once a week!
10. Maintenance and Repair
Always pull the power supply plug out of the
outlet before carrying out any maintenance or
cleaning work on the device!
Check the device regularly for any signs of dam-
age on the power supply cable, plug, fi nger pro-
tector, etc.
Any repairs that may be required are only al-
lowed to be carried out by authorised experts.
Please contact an authorised customer service
centre or your local dealer.
10.1 Grinding Disc Replacement
If the grinding performance decreases and the ground products
are hot and irregular, you should change the grinding discs.
1. Take the grinder apart as described under “9” and remove the
grinding discs from the grinder casing and the pre-breaker
using a screwdriver.
2. Clean the surfaces of the new grinding discs thoroughly and
screw them in position tightly and evenly.
3. Close the grinder casing again as described under “9” and set
the grind degree again as described under “8”.
13