Maico EC 140 B Mounting And Operating Instructions - page 12
17
8.1 EC 30 E, EC 40 D fastening rod
1 Disconnect motor connection cables [8]
from connecting terminal [7].
1 Slide up motor cover [11].
1 Carefully pull connection cable [8] at
bottom out of fastening rod [6].
1 Loosen retaining threaded pin of lock
nut [9].
1 Unscrew fastening rod [6] out of motor
housing.
1 Slide canopy [4] and setting ring [5] on to
new, long fastening rod [6.1].
1 Fully screw lock nut [9] in hole of fastening
rod.
1 Carefully screw in fastening rod [6.1] until
stop in motor housing is reached. Ensure
that the lock nut does not sit on the motor
housing.
1 Unscrew fastening rod until hole for cable
duct [B] and nut [M] are directly opposite
one another (nut [M] to right of tension
relief [Z]).
NOTICE
Unscrew fastening rod by no
more than 1 revolution.
1 In this position, tighten lock nut [9] to a
tightening torque of 20 Nm and secure with
threaded pin.
Tip: Place screwdriver between rubber
roller and fastening rod to counter them so
that the fastening rod is not twisted.
1 Slide enclosed insulation sleeve over motor
connection cables. This must protrude
around 20 mm beyond the existing
insulation sleeve [8].
1 Carefully thread insulation sleeve and
connection cables into fastening rod,
working from the bottom and moving
upwards. If necessary, use threading tool.
1 Slide down motor cover [11].
NOTICE
If the motor cover is
positioned wrongly, it cannot
be slid all the way down.
1 Turn motor cover [11] such
that recess [11.1] in motor
cover fits over motor cable [8].
1 Wire motor connection cables and
capacitor to connecting terminal according
to wiring diagram. For wiring diagram, see
back of instructions or inside of canopy.
1 Lift up ceiling fan.
1 Hang rubber roller of fastening rod [6] in
ceiling hook [1].
1 Undertake electrical connection according
to section 7.3.
CAUTION
Malfunction if the ceiling fan
cannot swing freely.
1 Leave 5 to 8 mm gap between
upper edge of canopy and
ceiling.
1 Slide canopy [4] towards ceiling and lock
with setting ring [5].
1 Start up ceiling fan according to section
7.4.
GB