Maidaid Halcyon C1011 Installation & User Manual

Summary of C1011

  • Page 1

    The engine shed top station road brackley nn13 7ug tel: 0845 1308060 fax: 01280 845345 web: www.Caterparts.Com all spares available from copyright notice: all rights reserved. No parts of this manual may be reproduced in any form without express written permission of maidaid-halcyon (a trading name ...

  • Page 2

    Instruction manual for dishwashers page 1 of 14 uk contents chap 1 preface ................................................................................................................... 2 chap 2 installation ..........................................................................................

  • Page 3

    Instruction manual for dishwashers page 2 of 14 uk chap 1 preface this manual contains important safety warnings relating to installation, use and maintenance. Failure to observe the instructions in the enclosed documentation may compromise the safety of the appliance and immediately voids the warra...

  • Page 4

    Instruction manual for dishwashers page 3 of 14 uk 2.2 positioning • check that there are no objects or materials in the installation area which may be damaged by the steam emitted by the appliance during operation, or if there are, make sure they are properly protected. • before positioning the app...

  • Page 5

    Instruction manual for dishwashers page 4 of 14 uk 2.4 water circuit hookup the appliance must be connected to its water supply with a flexible hose. A shut off valve (cock) must be installed between the water supply line and the appliance's solenoid valve. The cock must be close to the appliance. •...

  • Page 6

    Instruction manual for dishwashers page 5 of 14 uk chap 3 risks and important warnings • this appliance is intended solely for the use for which has been designed. Any other use is improper and hazardous. • the specialised technician responsible for installing the appliance must instruct the user on...

  • Page 7

    Instruction manual for dishwashers page 6 of 14 uk chap 4 using the machine 4.1 key and symbols referring to fig.1: 1 on/off button 4 information display 2 programme selection button 5 status bar (led) 3 start button 6 check bar (led) 4.2 switching the dishwasher on referring to fig.2: • turn on the...

  • Page 8

    Instruction manual for dishwashers page 7 of 14 uk 4.5 continuous washing (*optional) • this is an extended cycle; the time varies according to the model. • the cycle duration may be varied as required by pressing start (3) during the wash cycle, to interrupt the wash and start the rinse phase. 4.6 ...

  • Page 9

    Instruction manual for dishwashers page 8 of 14 uk 4.7 automatic cycle start-up this function is used to make the chosen cycle start automatically when the door is closed. To enable, proceed as follows (fig.6): • with the appliance on and the door open, press and hold (for at least five seconds) sta...

  • Page 10

    Instruction manual for dishwashers page 9 of 14 uk • rinse the area around the salt cap by hand and run a self-cleaning cycle to avoid any risk of corrosion. • the ‘salt’ warning will disappear after a few minutes. The warning reg on the display indicates that the machine is running a resin regenera...

  • Page 11

    Instruction manual for dishwashers page 10 of 14 uk chap 5 maintenance 5.1 general rules before doing any maintenance, completely drain out all water, shut off the power supply and close the water supply cock. Do not use water under pressure - it can damage the electrical equipment. Only wash the bo...

  • Page 12

    Instruction manual for dishwashers page 11 of 14 uk chap 6 self diagnostics the machine is equipped with a self-diagnosis system that registers and warns of a number of malfunctions. Fault description and possible remedies no rinsing. The rinsing cycle was not completed correctly. Make sure that the...

  • Page 13

    Instruction manual for dishwashers page 12 of 14 uk chap 7 settings the following settings should only be configured by a qualified technician. The parameters listed below can be set during installation of afterwards, accessing the settings menu as follows: • machine in standby with door open. • pre...

  • Page 14

    Instruction manual for dishwashers page 13 of 14 uk 7.1 hardness settings for the incorporated water softener set the hardness level of the water supply dh in the settings menu following the instructions given in the following table: measured hardness dh °fr dgh n° 0 ÷ 20 0 ÷ 11 1 21 ÷ 30 12 ÷ 16 2 ...

  • Page 15

    Instruction manual for dishwashers page 14 of 14 uk.