Maidaid Halcyon C1011 Installation & User Manual - page 9
INSTRUCTION MANUAL FOR DISHWASHERS
Page 8 of 14
UK
4.7 Automatic cycle start-up
This function is used to make the chosen cycle start automatically when the door is closed. To enable,
proceed as follows (Fig.6):
• With the appliance on and the door open, press and hold (for at least five seconds) START (3) until
AS appears on the display.
• To disable the function, with the door open press START (3) again for five seconds.
4.8 Removing the integral filter
• Move the washing and rinsing arms at right angles to the edge of the door (Fig.7).
• Lift each semi-filter by the relative handle.
4.9 Emptying the dishwasher
4.9.1 Appliances with no drain pump
•
Switch the dishwasher off.
•
Remove the integral filter ( Fig.7A).
•
Pull up and remove the overflow pipe ( Fig.8B ).
•
Wait for the tub to empty completely.
•
If necessary, extract the tub filter and clean ( Fig.8C ).
4.9.2 Appliances with drain cycle (*optional)
•
If present, remove the integral filter ( Fig.7 ).
•
If present, remove the overflow by pulling upwards ( Fig. 9 ).
•
Close the door.
•
Select the cycle dr
•
Press START (3) to start the cycle.
•
The machine runs a drain cycle with self-cleaning (*where foreseen) and then switches off.
•
If necessary, extract the tub filter and clean ( Fig.8C ).
4.10 Turning the dishwasher off
• Press ON/OFF (1), on the DISPLAY (4) the central segments will light up, indicating that the
machine is powered.
4.11
Resin regeneration (*optional)
I
n machines fitted with water softener, when the warning ‘SALt’ appears you should add salt to the
relative container; proceed as follows:
• Remove the basket from the machine.
• Remove the integral filter ( Fig. 7 ).
• Unscrew the cap on the salt container ( Fig. 11
).
• Pour in approx. 700g of large-grain kitchen salt, using the funnel supplied. (when filling for the first
time, fill the tank firstly with water)
• Close the container firmly.