Maidaid Halcyon C1011 Installation & User Manual - page 7
INSTRUCTION MANUAL FOR DISHWASHERS
Page 6 of 14
UK
Chap 4 USING THE MACHINE
4.1 Key and symbols
Referring to Fig.1:
1 ON/OFF BUTTON
4 INFORMATION
DISPLAY
2 PROGRAMME SELECTION BUTTON
5 STATUS BAR (LED)
3 START BUTTON
6 CHECK BAR (LED)
4.2
Switching the dishwasher on
Referring to Fig.2:
• Turn on the main power switch and open the external water tap.
• Check the presence of the overflow.
• Press ON/OFF (1).
• The CHECK BAR (6) lights up, turning from red to green to confirm the check. In the event of a
serious fault, the led bar lights up in red and stops the machine operation; a minor error is indicated
in orange, and will not stop the machine cycle.
• Loading begins automatically when the machine is switched on.
• The point on the display flashes until the level is reached.
• The STATUS BAR (5) lights up from the top downwards to indicate that the dishwasher is heating
up.
• When the working temperature is reached, the STATUS BAR (5) stays on, lit in green.
• The optimal wash conditions have been reached.
4.3
Filling the rack
Referring to
Fig. 3,to ensure the correct operation of the dishwasher follow the rules described below:
• Use a suitable rack, fill without overloading and without overlapping the dishes.
• Always wipe the dishes before placing in the dishwasher; do not put dishes with dry or solid
residues in the washer.
• Place the empty dishes in the rack facing downwards.
• Place plates and the like in the sloping rack, with the inner surface facing upwards.
• Place the cutlery in the cutlery basket, handle end down.
• Do not place silver and stainless steel cutlery in the same cutlery basket as this will turn the silver
brown and may corrode the steel.
• Wash the dishes immediately after use, in order to prevent any residue from hardening and sticking
on them.
• Use only solid, dishwasher-proof dishes.
4.4
Cycle selection and start-up
• Press the PROGRAMME SELECTION button (2) repeatedly to select a wash cycle that is suitable
for the dishes to be washed; the display will show the cycle number chosen (Fig. 4).
• To run the programme, press START (3); the STATUS BAR (5) starts to flash orange, increasing
from the bottom upwards to indicate the progression of the cycle.
• When the cycle is finished, the bar lights up in green (Fig. 5).
• For rapid drying, remove the rack from the machine as soon as the cycle finishes.
• To stop a wash cycle early, press START (3).
N.B. In hood versions, after the first work cycle the automatic start is automatically enabled; the
subsequent cycles will be enabled automatically when the hood is closed. This operating mode
is marked on the display by “AS”.