Please read this manual before installing and using appliance important: read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible fire hazard, and will void the warranty. Warning: if the information in this manual is not ...
3 360dvs series direct vent fireplaces 10006326 this gas appliance should be installed by a qualified installer in accordance with local building codes and current csa-b149.1 installation codes for gas burning appliances and equipment. If the unit is being installed in a mobile home, the installation...
4 360 dvs series direct vent fireplaces 10006326 j j k k h d a e b i e a f c h 6326 360dvs2 top vent specs electrical access gas line access electrical access gas line access k j j k j j g j j k k h d a e b e a f c k h 6326 360dvs2 rear vent specs g i electrical access gas line access electrical acc...
5 360dvs series direct vent fireplaces 10006326 i j k k rod 6326 360dvs3 rear vent specs b e c g f d a h h b electrical access gas line access c k j j i j k k 6326 360dvs3 top vent specs b e c f d a h h b electrical access gas line access k j j g fireplace dimensions - 360dvs3 / 306dvsl / 360dvsr re...
6 360 dvs series direct vent fireplaces 10006326 roh rod row cfm121 360dvs2 rear vent configuration 8/10/00 framing dimensions - 360dvs2 cfm122 360dvs2 - top vent configuration 8/10/00 rod roh row rear vent configuration top vent configuration cfm121 cfm122 framing dimensions ref. Rear vent configurati...
7 360dvs series direct vent fireplaces 10006326 cfm123_360dvs3_dims_rv2 rear vent configuration 8/10/00 rev. 8-23-02 rjs rod row rod roh roh roh rod 360dvsl 360dvs/3/l/r 360dvs3 360dvsr cfm124_360dvs3_tv2 top vent configuration 8/10/00 rev. 8-23-02 rjs rod rod roh row roh roh rod 360dvsl 360dvs/3/l/...
8 360 dvs series direct vent fireplaces 10006326 cfm170 dv builder front view o n m l k appliance top .........................................0” (0 mm) to standoff bottom ..................................................... 0” (0 mm) vent end ....................... 1/2” (13 mm) to rear panel nonv...
9 360dvs series direct vent fireplaces 10006326 final finishing 1. Choose the unit location. 2. Place the unit into position and secure it to the floor with 1 ¹⁄₂ ” (38mm) screws or nails. Holes to secure the unit to the floor are located behind the access door grille on the left and right sides of th...
10 360 dvs series direct vent fireplaces 10006326 the gas control is equipped with a captured-screw type pressure test point, therefore it is not necessary to pro- vide a 1/8” test point upstream of the control. When using copper or flex connector, use only ap- proved fittings. Always provide a union ...
11 360dvs series direct vent fireplaces 10006326 fp1430 fig. 8 alternate switch location. Optional top vent application this appliance is shipped as a rear vent unit. If the installation layout requires the unit to be a top vent con- figuration, the appliance can be converted by following the steps b...
12 360 dvs series direct vent fireplaces 10006326 electronic gas control valve this appliance may be fitted with a honeywell ignition module. Installation of the remote on/off starter switch on electronic ignition units (fig. 12): 1. Thread the wiring through the holes on the side panels of the appli...
13 360dvs series direct vent fireplaces 10006326 v v v v v v v x x x d e b b b c b m b a j k f l vent termination air supply inlet area where terminal is not permitted h i fixed closed fixed closed operabl e operable fixed closed v b cfm145a dv termin location 5/01/01 rev. 12/05/01 sta inside corner...
14 360 dvs series direct vent fireplaces 10006326 outside corner inside corner termination clearances termination clearances for buildings with combustible and noncombustible exteriors. A = combustible 6"(152mm) noncombustible 2"(50mm) b = combustible 6"(152mm) noncombustible 2"(50mm) a balcony - wi...
15 360dvs series direct vent fireplaces 10006326 how to use the vent graph the vent chart should be read in conjunction with the following vent installation instructions to determine the relationship of the vertical and horizontal dimensions of the vent system. 1. Determine the height of the center ...
16 360 dvs series direct vent fireplaces 10006326 vo584-100 vent opening 2/99 djt vent opening for combustible wall 9 ³⁄₈ ” (240mm) 10 ³⁄₈ ” (265mm) framing detail vent opening for noncombustible wall 7 ¹⁄₂ ” (190mm) vo584-100 fig. 18 locate vent opening on rear wall. Cfm135 zero clearance sleeve 2/...
17 360dvs series direct vent fireplaces 10006326 horizontal plane means no vertical rise exists on this portion of the vent assembly. • the maximum number of 90˚ elbows per side wall installation is three (3). • if a 90˚ elbow is fitted directly on top of the fireplace flange, the maximum horizontal ve...
18 360 dvs series direct vent fireplaces 10006326 step 3 place fireplace into position. (fig. 26) measure the verti- cal height (x) required from the base of the flue collars to the center of the wall opening. Vo584-100 vent opening 2/99 djt vent opening for combustible wall 9 ³⁄₈ ” (240mm) 9 ³⁄₈ ” (2...
19 360dvs series direct vent fireplaces 10006326 2” (51 mm). Secure termination to the wall with screws provided, and caulk around the wall plate to weather- proof. One alternative to screwing the termination directly to the wallis the use of expanding plugs or an approved exterior construction adhe...
20 360 dvs series direct vent fireplaces 10006326 vertical through-the-roof application this gas fireplace has been approved for: • vertical installations up to 40’ (12 m) in height. Up to a 10’ (3 m) horizontal vent run can be installed within the vent system using a maximum of two 90° elbows. (fig...
21 360dvs series direct vent fireplaces 10006326 vertical through-the-roof installation 1. Locate your fireplace. 2. Plumb to center of the (4”) flue collar from ceiling above and mark position. 3. Cut an opening equal to 9 ³⁄₈ ” x 9 ³⁄₈ ” (240 x 240mm). 4. Proceed to plumb for additional openings thr...
22 360 dvs series direct vent fireplaces 10006326 584b vent components starter kit 2/25/99 djt 584g venting components firestop spacer 2/25/99 djt 584h venting components attic insulation shield 2/25/99 djt 584i vent components offset support 2/25/99 djt 584f venting components pipe sections 2/25/99...
23 360dvs series direct vent fireplaces 10006326 operating instructions only glass approved by cfm corporation should be used on this fireplace. Glass information • the top side and top end louvres are removed by simply lifting the louvre assembly and pulling the as- sembly away from the fireplace. (f...
24 360 dvs series direct vent fireplaces 10006326 glass cleaning it is necessary to periodically clean glass. During start- up, condensation, which is normal, forms on the inside of the glass. This condensation causes lint, dust and other airborne particles to cling to glass surface. Also initial pa...
25 360dvs series direct vent fireplaces 10006326 lg320 360dvs logs b120 b121 b122 b123 b124 b126 b125 lg320 fig. 40 360dvs log placement. Side of fireplace v enting side v enting side lg321 360dvs logs opposite side b120 b121 b122 b123 b126 b125 side of fireplace lg321 fig. 41 360dvs log placement. ...
26 360 dvs series direct vent fireplaces 10006326 lo hi fp390 flame adjustment knob 11/21/96 turn counterclockwise to increase flame height turn clockwise to decrease flame height fig. 43 flame adjustment knob for sit valve. Flame characteristics it is important to periodically perform a visual chec...
34 360 dvs series direct vent fireplaces 10006326 burner and burner compartment it is important to keep the burner and the burner com- partment clean. At least once per year remove the logs and lava rock/ember material. Vacuum and wipe out the burner compartment. Remove and refit the logs per the ins...
35 360dvs series direct vent fireplaces 10006326 lo hi pilo t adj pilot on off 4a/b 5a/b 6 11 9 11 8 10 7 12 18 24 27 17 2 29 28 22 23 26 21 20 25 19 13 14 3a/b 15a/b 16a/b 6326 360dvs parts 31a/b 32 35 33 hi lo 34a/b 25 36 37 30 1 1a 1b 1c 1d 1e 1f 1g cfm corporation reserves the right to make chan...
36 360 dvs series direct vent fireplaces 10006326 360dvs series (items marked ‘*’ are not shown in the parts illustration) ref. Description 360dvs2 360dvs3 360dvsl 360dvsr 1. Log set (complete) 10006350 10006350 10006350 10006350 1a. Log - rear (b120) 10006315 10006315 10006315 10006315 1b. Log - fr...
37 360dvs series direct vent fireplaces 10006326 ref. Description 360dvs2 360dvs3 360dvsl 360dvsr 360dvs series (continued) (items marked ‘*’ are not shown in the parts illustration) 21. Louvre assembly, side bottom 10000040 10000040 10000040 10000040 22. Louvre assembly, end top n/a 10002411 100024...
43 360dvs series direct vent fireplaces 10006326 basic warranty cfm corporation (hereinafter referred to collectively as the company) warrants that your new vermont castings or majestic gas fireplace/ stove is free from manufacturing and material defects for a period of one year from the date of pur...
Efficiency ratings model energuide ratings steady state (%) d.O.E. Fireplace efficiency (%) fan-off fan-on (afue%) 360dvs2rn 62.4 83 84 65 360dvs2rp 62.4 83 84 65 360dvs2en 62.4 83 84 65 360dvs2ep 62.4 83 84 65 360dvs3rn 62.4 83 84 65 360dvs3rp 62.4 83 84 65 360dvs3en 62.4 83 84 65 360dvs3ep 62.4 83 8...
