Please read this manual before installing and using appliance important: read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible fire hazard, and will void the warranty. Warning: if the information in this manual is not...
2 360 dvs series direct vent fireplaces 10006326 installation and operating instructions ....................................................................................................... 3 important curing/burning instructions ......................................................................
3 360dvs series direct vent fireplaces 10006326 this gas appliance should be installed by a qualified installer in accordance with local building codes and current csa-b149.1 installation codes for gas burning appliances and equipment. If the unit is being installed in a mobile home, the installatio...
4 360 dvs series direct vent fireplaces 10006326 j j k k h d a e b i e a f c h electrical access gas line access electrical access gas line access k j j k j j g j j k k h d a e b e a f c k h g i electrical access gas line access electrical access gas line access j j k j j fireplace dimensions - 360d...
5 360dvs series direct vent fireplaces 10006326 i j k k rod b e c g f d a h h b electrical access gas line access c k j j i j k k b e c f d a h h b electrical access gas line access k j j g fireplace dimensions - 360dvs3 / 306dvsl / 360dvsr rear vent configuration top vent configuration ref. Rear ve...
6 360 dvs series direct vent fireplaces 10006326 roh rod row framing dimensions - 360dvs2 rod roh row rear vent configuration top vent configuration cfm121 cfm122 framing dimensions ref. Rear vent configuration top vent configuration rod 24” (610mm) minus two times finishing material thickness to be...
7 360dvs series direct vent fireplaces 10006326 rod row rod roh roh roh rod 360dvsl 360dvs/3/l/r 360dvs3 360dvsr rod rod roh row roh roh rod 360dvsl 360dvs/3/l/r 360dvs3 360dvsr framing dimensions - 360dvs3 / 360dvsl / 360dvsr rear vent confiration top vent configuration cfm123 cfm124 framing dimens...
8 360 dvs series direct vent fireplaces 10006326 appliance top ......................................... 0” (0mm) to standoff bottom ..................................................... 0” (0mm) vent end ....................... 1/2” (13mm) to rear panel nonvent end (dvs2) .............................
9 360dvs series direct vent fireplaces 10006326 final finishing 1. Choose the unit location. 2. Place the unit into position and secure it to the floor with 1 ¹⁄₂ ” (38mm) screws or nails. Holes to secure the unit to the floor are located behind the access door grille on the left and right sides of ...
10 360 dvs series direct vent fireplaces 10006326 the gas control is equipped with a captured-screw type pressure test point, therefore it is not necessary to provide a 1/8" test point upstream of the control. When using copper or flex connector, use only approved fittings. Always provide a union wh...
11 360dvs series direct vent fireplaces 10006326 fp1430 fig. 8 alternate switch location. Optional top vent application this appliance is shipped as a rear vent unit. If the installation layout requires the unit to be a top vent configuration, the appliance can be converted by following the steps be...
12 360 dvs series direct vent fireplaces 10006326 electronic gas control valve this appliance may be fitted with a honeywell ignition module. Installation of the remote on/off starter switch on electronic ignition units (fig. 12): 1. Thread the wiring through the holes on the side panels of the appl...
13 360dvs series direct vent fireplaces 10006326 v v v v v v v x x x d e b b b c b m b a j k f l vent termination air supply inlet area where terminal is not permitted h i fixed closed fixed closed operable operable fixed closed v b inside corner detail v a g v n n v v g g a cfm145a general venting ...
14 360 dvs series direct vent fireplaces 10006326 outside corner inside corner termination clearances termination clearances for buildings with combustible and noncombustible exteriors. A = combustible 6"(152mm) noncombustible 2"(50mm) b = combustible 6"(152mm) noncombustible 2"(50mm) a balcony - wi...
15 360dvs series direct vent fireplaces 10006326 how to use the vent graph the vent chart should be read in conjunction with the following vent installation instructions to determine the relationship of the vertical and horizontal dimensions of the vent system. 1. Determine the height of the center ...
16 360 dvs series direct vent fireplaces 10006326 vent opening for combustible wall 9 ³⁄₈ ” (240mm) 10 ³⁄₈ ” (265mm) framing detail vent opening for noncombustible wall 7 ¹⁄₂ ” (190mm) vo584-100 fig. 18 locate vent opening on rear wall. Maximum length 12” (305mm) #8 screws (2) #8 screws (2) firestop...
17 360dvs series direct vent fireplaces 10006326 horizontal plane means no vertical rise exists on this portion of the vent assembly. • the maximum number of 90˚ elbows per side wall installation is three (3). • if a 90˚ elbow is fitted directly on top of the fireplace flange, the maximum horizontal...
18 360 dvs series direct vent fireplaces 10006326 step 3 place fireplace into position. (fig. 26) measure the vertical height (x) required from the base of the flue collars to the center of the wall opening. Vent opening for combustible wall 9 ³⁄₈ ” (240mm) 9 ³⁄₈ ” (240mm) framing detail vent openin...
19 360dvs series direct vent fireplaces 10006326 2” (51mm). Secure termination to the wall with screws provided, and caulk around the wall plate to weather- proof. One alternative to screwing the termination directly to the wallis the use of expanding plugs or an approved exterior construction adhes...
20 360 dvs series direct vent fireplaces 10006326 vertical through-the-roof application this gas fireplace has been approved for: • vertical installations up to 40’ (12m) in height. Up to a 10’ (3m) horizontal vent run can be installed within the vent system using a maximum of two 90 ° elbows. (fig....
21 360dvs series direct vent fireplaces 10006326 vertical through-the-roof installation 1. Locate your fireplace. 2. Plumb to center of the (4”) flue collar from ceiling above and mark position. 3. Cut an opening equal to 9 ³⁄₈ ” x 9 ³⁄₈ ” (240 x 240mm). 4. Proceed to plumb for additional openings t...
22 360 dvs series direct vent fireplaces 10006326 7tdvrvt through-the-wall rear vent termination starter kit model 7tdvsk - sidewall starter kit model 7tdvskv - vertical venting for 7tdvskv-a: order 1/12 to 6/12 roof pitch for 7tdvskv-b: order 7/12 to 12/12 roof pitch for 7tdvskv-f: order flat roof ...
23 360dvs series direct vent fireplaces 10006326 operating instructions only glass approved by cfm specialty home products should be used on this fireplace. Glass information • the top side and top end louvres are removed by simply lifting the louvre assembly and pulling the assembly away from the f...
24 360 dvs series direct vent fireplaces 10006326 glass cleaning it is necessary to periodically clean glass. During start- up, condensation, which is normal, forms on the inside of the glass. This condensation causes lint, dust and other airborne particles to cling to glass surface. Also initial pa...
25 360dvs series direct vent fireplaces 10006326 lava rock and ember material placement your log set contains ember material and two types of lava rocks. Set these materials in place after the logs have been installed. Ember material (pt. #51915) remove ember material from the bag and separate it in...
26 360 dvs series direct vent fireplaces 10006326 1. Stop! Read the safety information above. 2. Turn off all electrical power to the fireplace. 3. For mn/mp/tn/tp appliances only, go on to step 4. For rn/rp appliances turn the on/off switch to “off” position or set thermostat to lowest level. 4. Op...
27 360dvs series direct vent fireplaces 10006326 lighting and operating instructions for fireplaces equipped with sit822 gas valve (en or ep) a. This fireplace is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand. B. Before operating, smell ...
28 360 dvs series direct vent fireplaces 10006326 note: before troubleshooting the gas control system, be sure external gas shut off is in the “on” position. Sit nova 820 millivolt valve troubleshooting the gas control system warning: remove glass front before doing any gas control service work. Sym...
29 360dvs series direct vent fireplaces 10006326 sit 822 valve with a honeywell electronic igniter note: remove glass before servicing. Start turn gas supply off. Turn on/off switch to call for heat. Power to module? (24v normal) spark across ignitor sensor gap? Yes yes yes turn gas on. Pilot burner...
30 360 dvs series direct vent fireplaces 10006326 troubleshooting – honeywell vs8421 start check gas supply on ▼ ▼ ▼ ▼ ▼ pilot lights with piezo ignitor • lockout has engaged. Wait 60 seconds and try again. • for spark at electrode while depressing piezo 1/8" gap to pilot hood needed. • all wiring c...
31 360dvs series direct vent fireplaces 10006326 fuel conversion instructions to convert this appliance from gas type to another, follow these instructions. Before proceeding, turn control knob to “off” and turn gas supply off. Turn off any electricity that may be going to the appliance. Caution: lo...
32 360 dvs series direct vent fireplaces 10006326 d e f off p ilot on fc108 fig. 48 replace regulator. 10. Reassemble fireplace in the reverse order, except for the window frame assembly. Leave this off until after unit has been checked for leaks and the gas supply has been bled. 11.After bleeding t...
33 360dvs series direct vent fireplaces 10006326 burner and burner compartment it is important to keep the burner and the burner compartment clean. At least once per year remove the logs and lava rock/ember material. Vacuum and wipe out the burner compartment. Remove and refit the logs per the instr...
34 360 dvs series direct vent fireplaces 10006326 lo h i pilot adj pilot on off 4a/b 5a/b 6 11 9 11 8 10 7 12 18 24 27 17 2 29 28 22 23 26 21 20 25 19 13 14 3a/b 15a/b 16a/b 31a/b 32 35 33 hi lo 34a/b 25 36 37 30 1 1a 1b 1c 1d 1e 1f 1g cfm specialty home products reserves the right to make changes i...
35 360dvs series direct vent fireplaces 10006326 360dvs series (items marked ‘*’ are not shown in the parts illustration) ref. Description 360dvs2 360dvs3 360dvsl 360dvsr 1. Log set (complete) 10006350 10006350 10006350 10006350 1a. Log - rear (b120) 10006315 10006315 10006315 10006315 1b. Log - fro...
36 360 dvs series direct vent fireplaces 10006326 ref. Description 360dvs2 360dvs3 360dvsl 360dvsr 360dvs series (continued) (items marked ‘*’ are not shown in the parts illustration) 19. Remote on/off switch (rn/rp models) 51842 51842 51842 51842 * wiring harness (remote switch) 55923 55923 55923 5...
37 360dvs series direct vent fireplaces 10006326 optional accessories fan kits fk24 fan assembly this auxiliary fan system increases the efficiency of the circulation of the heated air. The fk24 fan kit allows variable speed control of the circulation fan and also incorporates a heat sensor in the c...
38 360 dvs series direct vent fireplaces 10006326 wiring instructions the fireplace, when installed, must be electrically connected and grounded in accordance with local codes, or in the absence of local codes, with the current csa c22.1 canadian electric code. For usa installations, follow local co...
39 360dvs series direct vent fireplaces 10006326 basic warranty cfm specialty home products (hereinafter referred to collectively as the company) warrants that your new vermont castings or majestic gas fireplace/stove is free from manufacturing and material defects for a period of one year from the ...
Efficiency ratings model energuide ratings steady state (%) d.O.E. Fireplace efficiency (%) fan-off fan-on (afue%) 360dvs2rn 62.4 83 84 65 360dvs2rp 62.4 83 84 65 360dvs2en 62.4 83 84 65 360dvs2ep 62.4 83 84 65 360dvs3rn 62.4 83 84 65 360dvs3rp 62.4 83 84 65 360dvs3en 62.4 83 84 65 360dvs3ep 62.4 83...
