Majestic DVD2000 User Manual - page 10
With about 4m
7
Preparing the remote control
Notes on battery
Notes on the remote control
Do not expose the remote sensor of the DVD player and the remote control to a strong light source
such as direct sunlight or other illumination. If you do so, you may not be able to operate the DVD
player via the remote control.
To operate the remote control correctly, follow the instructions below.
Do not insert cell into the remote control in the wrong direction.
Do not charge, heat, open, or short-circuit the cell. Do not throw cell into a fire.
If the remote control does not function correctly or if the operating range becomes reduced,
replace the cell with new one.
Direct the remote control at the remote sensor of the DVD player.
Do not drop or give the remote control a shock.
Do not leave the remote control near an extremely hot or humid place.
Do not spill water or put anything wet on the remote control.
Do not disassemble the remote control.
Operating with the remote control
This section shows you how to use the
remote control. Point the remote control
at the remote sensor and press the buttons.
The remote range: about 4m from the front
of the remote sensor.
(Is) off axis: more than 30
L
in each direction
of the front of the remote sensor.
Insert battery (3V, CR2025) into the remote control.
Make sure the + side of the battery faces up before closing the cover.
When using remote control
+
3 V
1) Open the cover,
pull the cover as illustrated
2) Insert cell (3V)
3)Close the cover
+
3 V
POWER
POWER
SUB
SUB
ANGLE
ANGLE
AUDIO
AUDIO
GOTO
GOTO
PHONE
PHONE
VOL
VOL
VOL
VOL
MENU
MENU
ZOOM
ZOOM
RETURN
RETURN
SOURCE
SOURCE
11
22
33
44
55
66
77
88
99
00
CLEAR
CLEAR
ENTER
ENTER
SETUP
SETUP
SEL
SEL
MUTE
MUTE
LOUD
LOUD
TITLE
TITLE
PBC
PBC
SLOW
SLOW
REPEAT
REPEAT
PROG
PROG
AMP SEL
AMP SEL
DISPLAY
DISPLAY
SCREEN
SCREEN
N/P
N/P
VOCAL
VOCAL
STEP
STEP
//