1 engl ish instruction manual warning: for your personal safety, read and understand before using. Save these instructions for future reference. Cordless hammer driver drill bhp343 bhp453 009083.
2 english specifications model bhp343 bhp453 concrete 10 mm 13 mm steel 10 mm 13 mm wood 25 mm 36 mm wood screw 5.1 mm x 63 mm 6 mm x 75 mm capacities machine screw 6 mm high (2) 0- 1,300 no load speed (min -1 ) low (1) 0 - 400 high (2) 0 - 19,500 blows per minute (min -1 ) low (1) 0 - 6,000 overall...
3 enh102-7 ec-declaration of conformity model; bhp343,bhp453 we declare under our sole responsibility that this product is in compliance with the following standards of standardized documents; en60745, en55014 in accordance with council directives, 2004/108/ec, 98/37/ec. Ce2007 000230 tomoyasu kato ...
4 power tool use and care 17. Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. 18. Do not use the power tool if the switch does not turn it on and off. Any power tool that cann...
5 enc007-2 important safety instructions for battery cartridge 1. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. 2. Do not disassemble battery cartridge. 3. If operating time has become excessively sho...
6 to start the tool, simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. Release the switch trigger to stop. Reversing switch action a b 1 009086 this tool has a reversing switch to change the direction of rotation. Depress the reversing switch lever...
7 assembly caution: • always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Installing or removing driver bit or drill bit 1 009088 turn the sleeve counterclockwise to open the chuck jaws. Place the bit in the chuck as far as it w...
8 drilling operation first, turn the adjusting ring so that the pointer points to the marking. Then proceed as follows. Caution: • pressing excessively on the tool will not speed up the drilling. In fact, this excessive pressure will only serve to damage the tip of your bit, decrease the tool perfor...
9.
10
11.
12 makita corporation anjo, aichi, japan 884820-224.
