Makita DA4000LR Instruction Manual - Assembly
5
Reversing switch action
1
A
B
003029
This tool has a reversing switch to change the rotational
direction. Move the reversing switch lever to the "A" side
for clockwise (forward) rotation or the "B" side for
counterclockwise (reverse) rotation.
CAUTION:
•
Always check the rotational direction before
operation.
•
Use the reversing switch only after the tool comes
to a complete stop. It will damage the tool to
change the rotational direction before the tool
stops.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing side grip (auxiliary handle)
CAUTION:
•
Always use the side grip and hold it with both hands
to ensure operating safety.
Use of it with angle attachment
004651
Screw the side grip for the angle attachment on the angle
housing. Then tighten the side grip by turning clockwise
at the desired position.
Use of it without angle attachment
004652
Screw the side grip on the tool barrel securely. The side
grip can be installed on either side of the tool, whichever
is convenient.
Installing or removing angle attachment
HIGH
HIGH
LOW
LOW
1
2
004655
The angle head has a spindle on each end. For higher
speed operation, attach the drill chuck to the end marked
"HIGH". The higher speed is better suited for drilling
smaller diameter holes.
For lower speed operation, attach the drill chuck to the
end marked "LOW". The lower speed is best utilized for
drilling larger diameter holes.
The tool is factory assembled with the chuck on spindle
end marked "HIGH". To change to the "LOW" speed,
proceed as follows:
To remove the drill chuck, first open the chuck jaws
completely and place the chuck key in one of the key
holes.
1
2
004656
Remove the chuck remaining bolt through the chuck
opening by turning it counterclockwise with the hex
wrench.
1. Chuck key
2. Drill chuck
1. High
2. Low
1. Reversing
switch lever