Makita JV100D Technical Information

Summary of JV100D

  • Page 1

    Jig saw blade no. B-10 .................................. 1 hex wrench ................................................... 1 guide rule set (for some countries only) ........ 1 note: the standard equipment for the tool shown above may vary by country. Jig saw blades guide rule set hose 28 cover plat...

  • Page 2

    P 2/ 11 r epair apply makita grease n. No.1 to the following portions designated with the black triangle to protect parts and product from unusual abrasion. [1] necessary repairing tools caution: repair the machine in accordance with “instruction manual” or “safety instructions”. Code no. Descriptio...

  • Page 3

    R epair [3] disassembly/assembly [3] -1. Housing disassembling fig. 2 fig. 3 4x35 tapping screw (1 pc.) housing r clamp plate hex wrench 3 (standard equipment) m4x16 hex socket head bolt 4x18 tapping screw (9 pc.) assembling base note; before assembling housing r, make sure that holder (with m4 scre...

  • Page 4

    R epair [3] disassembly/assembly [3] -2. Reciprocating mechanism disassembling 2. Turn dc motor shaft to move collared sleeve 4 up to the top position of slider’s elliptical hole. 4. Remove slider section from the collared sleeve 4. 5 . Remove collared sleeve 4. 7. Now, remove gear complete and pin ...

  • Page 5

    R epair [3] disassembly/assembly [3] -2. Reciprocating mechanism assembling (1) assemble bearing case complete to dc motor (fig. 5). Fig. 5 fig. 6 retaining ring s-6 1. Shake push plate up and down while pressing gear complete toward balance plate. 2. Now, the assembling groove on pin comes into you...

  • Page 6

    R epair [3] disassembly/assembly [3] -2. Reciprocating mechanism (cont.) assembling (4) after setting dc motor and reciprocating mechanism to housing l, assemble slider section and leaf spring (fig. 7). Fig. 7 5. Make sure to insert o ring 5 into the bottom of assembling holes for slider guide. 7. A...

  • Page 7

    R epair [3] disassembly/assembly [3] -2. Reciprocating mechanism assembling assembling disassembling [3] -3. Lever 19 fig. 8 11. Assemble housing r while inserting change lever into the assembling hole. 10. Mount change lever to the switch while inserting the protrusion of switch into the hole of ch...

  • Page 8

    C ircuit diagram w iring diagram orange line filter housing l side handle side handle side housing l side housing l side housing l side connect flag terminals of the lead wires to terminals of dc motor and route the lead wires through line filter. Color index of lead wires' sheath black red switch d...

  • Page 9

    W iring diagram fig. D-3 store lead wires in these lead wire holders so as not to protrude and interfere with housing r when assembled. Do not overlap the lead wires under switch (fig. D-2). Housing l switch line filter rib route all lead wires to switch from dc motor in this slot of rib when line f...

  • Page 10

    C ircuit diagram w iring diagram housing l side handle side handle side lead wire (red) housing l side housing l side housing l side color index of lead wires' sheath for the countries where the regulations for radio interference suppression are not required. Switch dc motor terminal for the countri...

  • Page 11

    W iring diagram fig. D-3a housing l side switch line filter rib for the countries where the regulations for radio interference suppression are not required. Store lead wires in these lead wire holders so as not to protrude and interfere with housing r when assembled. Do not overlap the lead wires un...