Instruction manual portable cut-off lw1400 lw1401 eng lish: o rig in al in stru cti on s double insulation read before use..
2 english specifications model: lw1400 lw1401 wheel diameter 355 mm hole diameter 25.4 mm no load speed 3,800 min -1 dimensions (l x w x h) with european type safety guard 530 mm x 295 mm x 640 mm 500 mm x 295 mm x 640 mm with safety guard other than european type 530 mm x 290 mm x 640 mm 500 mm x 2...
3 english 5. When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. 6. If operating a power tool in a damp location is unavoidable, use a residual current device (rcd) protected supply. Use of a...
4 english 15. If the wheel stops during the operation, makes an odd noise or begins to vibrate, switch off the tool immediately. 16. Always switch off and wait for the wheel to come to a complete stop before removing, securing workpiece, working vise, changing work position, angle or the wheel itsel...
5 english 1 2 ► 1. Lock button / lock-off button 2. Switch trigger for tool with lock button to start the tool, simply pull the switch trigger. Release the switch trigger to stop. For continuous operation, pull the switch trigger, push in the lock button and then release the switch trigger. To stop ...
6 english 1 2 ► 1. Guide plate 2. Lever for lw1401 notice: when performing right miter cut, always set the guide plate at 0 - 170 mm position. Setting at the 35 - 205 mm or 70 - 240 mm position hinders the movement of stopper plate, which results in a failure cut. Loosen the two hex bolts using a so...
7 english opening center cap type safety guard country specific for the tools equipped with center cap type safety guard, loosen the clamping screw first then raise the guard. 1 ► 1. Clamping screw opening european type safety guard country specific for the tools equipped with european type safety g...
8 english 2 1 ► 1. Shaft lock 2. Toolless clamp to install the cut-off wheel, follow the removal proce- dures in reverse. Make sure to fit the hole of cut-off wheel to the ring and return the safety guard. For lw1401 raise the safety guard. Turn the hex bolt counterclock- wise using a socket wrench ...
9 english 1 ► 1. Spacer block when cutting workpieces over 85 mm wide at an angle, attach a straight piece of wood (spacer) over 190 mm long x 45 mm wide to the guide plate as shown in the figure. Attach this spacer with screws through the holes in the guide plate. Make sure that the cut-off wheel d...
10 english notice: never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result. Replacing carbon brushes 1 ► 1. Limit mark check the carbon brushes regularly. Replace them when they wear down to the limit mark. Keep the carbon brushes clean and free to ...
11.
Makita corporation www.Makita.Com 885456-6 en 20150819.
