Instruction manual portable cut-off lw1400 lw1401 en g l ish : o rig in a l i n s tr u c ti o n s double insulation read before use..
2 english specifications model: lw1400 lw1401 wheel diameter 355 mm max. Wheel thickness 3 mm hole diameter 25.4 mm no load speed 3,800 min -1 dimensions (l x w x h) with european type safety guard 530 mm x 295 mm x 640 mm 500 mm x 295 mm x 640 mm with safety guard other than european type 530 mm x ...
3 english 4. Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or moving parts. Damaged or entangled cords increase the risk of electric shock. 5. When operating a power tool outdoors, use an extension cord suitab...
4 english 6. The outside diameter and the thickness of your accessory must be within the capacity rating of your power tool. Incorrectly sized accessories cannot be adequately guarded or controlled. 7. The arbour size of wheels and langes must properly it the spindle of the power tool. Wheels and la...
5 english 10. Remove material or debris from the area that might be ignited by sparks. Be sure that others are not in the path of the sparks. Keep a proper, charged ire extinguisher closely available. 11. If the wheel stops during the operation, makes an odd noise or begins to vibrate, switch off th...
6 english 1 2 1. Lock button / lock-off button 2. Switch trigger for tool with lock button to start the tool, simply pull the switch trigger. Release the switch trigger to stop. For continuous operation, pull the switch trigger, push in the lock button and then release the switch trigger. To stop th...
7 english for lw1400 turn the lever counterclockwise. Move the guide plate to the desired angle and fully tighten the lever. 1 2 1. Guide plate 2. Lever for lw1401 notice: when performing right miter cut, always set the guide plate at 0 - 170 mm position. Setting at the 35 - 205 mm or 70 - 240 mm po...
8 english opening center cap type safety guard country speciic for the tools equipped with center cap type safety guard, loosen the clamping screw irst then raise the guard. 1 1. Clamping screw opening european type safety guard country speciic for the tools equipped with european type safety guard,...
9 english 2 1 1. Shaft lock 2. Toolless clamp to install the cut-off wheel, follow the removal proce- dures in reverse. Make sure to it the hole of cut-off wheel to the ring and return the safety guard. For lw1401 raise the safety guard. Turn the hex bolt counterclock- wise using a socket wrench whi...
10 english 1 1. Spacer block when cutting workpieces over 85 mm wide at an angle, attach a straight piece of wood (spacer) over 190 mm long x 45 mm wide to the guide plate as shown in the igure. Attach this spacer with screws through the holes in the guide plate. Make sure that the cut-off wheel doe...
11 english maintenance caution: always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. Notice: never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result. Replacing carbon brushes 1 1. Limit m...
M a k i t a c o r p o r a t i o n 3-11-8, sumiyoshi-cho, anjo, aichi 446-8502 japan www.Makita.Com 885456c931 en 20170106.
