1 1 lpgsasa permit number: 1185-34/1-rsa-12-a assembly & operating instructions important: read these instructions for use carefully so as to familiarize yourself with the appliance before connecting it to its gas container. Keep these instructions for future reference 2 patio heater powder coated /...
2 warning • for outdoor use only • read the instruction before installation and use. • keep the instructions for future references. Warning • do not store use gasoline or other flammable vapors and liquids in the vicinity of any other appliance. • an lp cylinder not connected for use shall not be st...
3 table of contents caution…………………………………………………………………………….4 heater stand and location…………………………………………………….6 gas requirements………………………………………………………………6 leakage test……………………………………………………………………..7 fuel gas odour………………………………………………………………….7 pre-operation check...…………………………………………………………8 lighting instructions...
4 caution please read carefully the following safety guidelines before operation • do not make any unnecessary adjustments or modifications to this grill, a qualified lp gas technician should do any adjustments • improper installation, adjustment, alteration can cause personal injury or property dam...
5 replaced before operating the heater. • change the gas cylinder in a well-ventilated area, away from any ignition source. • check that the regulator seal is fitted and that it is in good condition. • do not obstruct the ventilation holes of cylinder housing. • adults and children should stay form ...
6 heater stand and location • the heater is primarily for outdoor use only. Always ensure that adequate fresh air ventilation is provided. • always maintain proper clearance to combustible materials, i.E. Top 2m and sides 2m minimum. Heater must be placed on level firm ground. • never operate heater...
7 leakage test gas connections on the heater are leak tested at the factory prior to shipment. A complete gas tightness check must be performed at the installation site due to possible mishandling in shipment or excessive pressure being applied to the heater. • the heater must be checked with a full...
8 have them air out the building and area before you return. Properly trained service people must repair any leaks, check for further leakages, and then relight the appliance for you. Pre-operation check a. Remove the observation window panel by un-screwing the two bolts. B. Turn on the lp gas cylin...
9 lighting instructions to turn on the heater 1. Turn the control knob to the “off” position 2. Turn on the valve on the gas supply cylinder completely. 3. Press and turn the variable control knob to “low” position (counter-clockwise 90º) 4. Press down the variable control knob and hold for 30 secon...
10 flame characteristics the flame pattern at the emitter screen should be visually checked whenever the heater is operated. Normally the burner flame is blue, but little yellow flames are acceptable. If the flames extend beyond the surface of the emitter grid, or the phenomena of flame lift or burn...
11 • heater does not reach the desired temperature. • heater glow is excessively uneven. • heater makes popping noises. • spiders and insects can nest in burner or orifices. This dangerous condition can damage heater and render it unsafe for use. Clean burner holes by using a heavy-duty pipe cleaner...
12 assembly instructions a shifting spanner / wrench and phillips screwdriver are required to complete the assembly of this product. Nb: this model (srph09) doe not include the wheels or associated parts that are depicted in this manual and any of the diagrams. Please check above components and hard...
13 parts and hardware.
14 step 1 step 2.
15 step 3 step 4.
16 step 5.
17 step 6.
18 service and maintenance information lf the pilot heater fails to operate correctly, contact place of purchase or their authorized service agent for advice and service. Megamaster customer service +27 (0) 12 802 1515. Do not attempt repairs yourself. Periodic maintenance should be performed at int...
19 burner ports. To clean the burner ports, remove the reflector assembly by removing the three nuts at the top of the reflector. The mesh screen should then be extracted by removing the four retention screws at the base of the mesh screen and four screws at the top of the screen. Remove the two scr...
20 warranty this patio heater has a one (1) year limited warranty. The warranty period is valid from the date of purchase. This is subject to correct assembly, use, storage and regular maintenance of the product. This product is intended for use with a 9kg lp gas cylinder, use of any other cylinder ...
21 for outdoor use only this appliance complies with the requirements of sans 1539 www.Megamaster.Co.Za manufactured in china· distributed by megamaster · po box 15, woodlands, 0027, south africa· tel: +27(0) 12 802 1515 warning read and follow all safety, assembly, and use & care instructions in th...
