Megamaster SRPH09 Assembly & Operating Instructions - page 19
19
burner ports.
To clean the burner ports, remove the reflector assembly by removing the three nuts at the
top of the reflector. The mesh screen should then be extracted by removing the four
retention screws at the base of the mesh screen and four screws at the top of the screen.
Remove the two screws retaining the burner assembly, rotate the burner assembly slightly
then remove the burner assembly upwards.
Care should always be taken to avoid damage to the gas piping and Piezo ignition lead.
The burner and mesh screen should then be cleaned by compressed air. Assembly is a
reversal of the above procedure.
If the pilot is blocked by debris, spider webs etc. the pilot flame may be small and the flame
failure device may have not heated up enough for the main burner to come on. If this
happens it will be necessary to clean the pilot and its gas tube.
To clean the pilot, remove the burner and pilot cover as detailed above, Inspect the pilot
injector and tubing for blockage. If obstructed clean with compressed air. Clean the flame
failure device. Assembly is a reversal of the above procedure.
TECHNICAL INFORMATION
Item
Outdoor Patio Heater
Serial No:
Model
SRPH09
Country Destination
ZAR
Type of gas
LP GAS
Pressure (kPa)
2,8
Category
I3 (28-‐30)
Gas Consumption
830g/hr.
Heat Output
12.0kW
Injector Diameter
1,90mm
Manufacturer/Importer
Megamaster South Africa
•
Close the valve of the gas cylinder after use.
•
Read the instructions before using this appliance.
•
For use outdoors and in well ventilated areas.
•
The use of this appliance in enclosed areas can be dangerous and is PROHIBITED.
•
This appliance must be installed and assembled in accordance with SANS 1359:2012.
•
A well-‐ventilated area must have a minimum of 25% of the surface area open.
•
The surface area is the sum of the walls surface.