MEGAPLUS GigE Vision Features Manual - page 13
MEGAPLUS
GigE Vision Features Guide (Customer Edition)
4411-0128, Rev. A
07/28/09
9
Triggered mode operation provides a larger range of integration times. Free-run
integration time is limited to one frame-readout time at the current clock rate.
TriggerState: (R/W) This feature turns triggering ON or OFF. When triggering is enabled
(checked), the camera will recognize and respond to trigger events in the manner dictated
by the trigger mode. When triggering is disabled (unchecked), all trigger signals will be
ignored and the camera will operate in a free-run video mode. Checked/Unchecked
TriggeringMode: (R/W) This feature sets/returns the trigger mode for the controller. Note: In
addition to setting the trigger mode, triggering must be enabled with the TriggerState
feature in order for triggered operation to take effect. EdgeControlled, LevelControlled,
DoubleExposureMode, PeriodicInterval, OverlappedEdge
TriggeringSource: (R/W) This feature specifies/returns the input source that will initiate the
trigger event. Sources can include: external trigger (via BNC on controller rear panel) or
software trigger. The software trigger command only applies to mode 0 (Edge Trigger,
Asynchronous Reset) and 7 (Overlapped Edge Mode). Use the TriggerSoftware feature to
cause a software trigger event. BNC/Software
WhiteBalanceAuto: (R/W) This feature sets the white balance for the currently selected head.
The system uses the default head value of 1. The camera will perform a semi-auto white
balance. Execute
WhiteBalanceBlue: (R/W) This feature sets/returns the white balance for the camera. The values
specified for blue is relative to green, which is the master color. The value for green is always
1.0. Min: 0, Max: 64
WhiteBalanceRed: (R/W) This feature sets/returns the white balance for the camera. The values
specified for red is relative to green, which is the master color. The value for green is always
1.0. Min: 0, Max: 64