Ke680 1 ke 680 deluxe 4-channel keyless entry system door lock relays on-board installation and operation manual megatronix chatsworth, ca u.S.A..
Ke680 2 installation diagram h1: main 5 pin white harness h8: 10 pin white mini connector led indicator valet switch h4 6 pin white h6 4 pin orange h3 2 pin blue h5 2 pin white h7 4 pin black no use h1 5 pin white h8 10 pin white h4: 6 pin door lock / unlock wire harness transceiver antenna h2 3 pin...
Ke680 3 keep wiring away from moving engine parts, exhaust pipes, and high-tension cable. Tape wires that pass through holes on the firewall to prevent frying electrical. Watch out for sharp edges that may damage wires and causes short circuit. Caution: do not connect the wire harness to the control...
Ke680 4 b). When found, use voltmeter, connect one probe of the voltmeter to ground and connect the other end of the probe to the starter wire. It should receive "12 volts" only when the ignition key in the "start" position. C). After locating the correct wire, cut it in half, try to start the vehic...
Ke680 5 h4. 6 pin door lock harness: blue/white wire: (30) - door unlock relay blue/red wire: (87a) - door unlock relay blue/yellow wire: (87) - door unlock relay green/red wire: (87a) - door lock relay green/white wire: (30) - door lock relay green/yellow wire: (87) - door lock relay install new do...
Ke680 6 2 step door unlock wire connection for ground switched door locks cut existing unlock wire x lock unlock oem door master lock switch to all other door lock motor lt. Green / black wire oem driver's door lock motor blue / white green / white green / yellow existing lock wire existing unlock w...
Ke680 7 feature “ ii ” proramming: 1. Turn the ignition switch ‘on/off’ 3 times and stay in the off position. 2. Push the valet switch 4 times and hold it on the 4 th push until two chirps with a long chirp is heard. Then release the valet switch. You are now in the feature ‘ii’ programming mode. 3....
Ke680 8 3-a. Press and release the transmitter or f button 3 times, [3] led flash, [3] siren/horn chirp to indicate you are in features “channel 3 timer programming mode”. 3-b. Press and release the transmitter or button 4 times, [4] led flash, [4] siren/horn chirp to indicate you are in features “c...
Ke680 9 delete password pin code (override without password pin code): (factory default setting) 1. Turn the ignition switch ‘on/off’ 3 times and stay in the off position. 2. Push the valet switch 8 times and hold it on the 8 th push until four chirps with a long chirp is heard. Then release the val...
Ke680 10 operation: transmitter operation: transmitter button system function remark lock doors and arm system + silent arming / disarming ignition in "off" position. Unlock doors and disarm system - 2-step door unlock and disarm system press twice within 3 seconds (2-second) trunk release (channel ...
Ke680 11 the override function may be used if the remote transmitter is lost or inoperative. 1. Enter the vehicle and turn the ignition switch to 'on’ position. (alarm will sound.) 2. Within 10 seconds push and release the valet switch. The system will stop sounding and enter the disarm mode. You ca...
Ke680 12 m. Dome light convenience delay & supervision the alarm has a unique feature that will turn on your vehicle dome light as following: 1. Upon disarming, the interior lights will remain on for 30 seconds. 2. If the vehicle is intruded, the interior light will flash for the same duration as th...
