MEGATRONIX KE 680 Installation And Operation Manual - page 6
KE680
6
2 STEP DOOR UNLOCK WIRE CONNECTION FOR
GROUND SWITCHED DOOR LOCKS
Cut Existing Unlock
Wire
X
Lock
Unlock
OEM Door Master Lock Switch
To All Other
Door Lock
Motor
LT. Green / Black
Wire
OEM
Driver's
Door Lock
Motor
Blue / White
Green / White
Green / Yellow
Existing
Lock Wire
Existing
Unlock Wire
H4
6-Pin
Door
Lock
Wire
Harness
Blue / Red
Blue / Yellow
+12V
OEM Door
Lock Relay
2 STEP DOOR UNLOCK WIRE CONNECTION FOR
POSITIVE SWITCHED DOOR LOCKS
Cut Existing Unlock
Wire
X
Lock
Unlock
OEM Door Master Lock
Switch
To All Other
Door Lock
Motors
LT. Green /
Black Wire
OEM Driver's
Door Lock
Motor
+ 12V
Blue / Red
Existing Pos.
Lock Wire
Existing Pos.
Unlock Wire
30
87A
87
86
85
+12V
Blue / White
Green / White
Green / Yellow
Blue / Yellow
+ 12V
OEM Door
Lock Relay
H4
6-Pin
Door
Lock
Wire
Harness
PROGRAMMING
A. THE TRANSMITTERS:
Note: This mode will only retain the last 4 remote transmitters programmed. If the transmitter memory is
exceeded, the system will start deleting transmitters from the memory in chronological order.
1. Turn the Ignition switch ‘OFF/ON’ 3 TIMES and stay in the ON position. Within 15 seconds.
2. Push the Valet switch 3 times and holding in on 3rd push until a long chirp is heard. Then release the
valet switch. You are now in the Transmitter programming mode.
3. Press and hold any button of the transmitter until the siren responds with a confirming chirp, indicating
the signal has been stored into memory.
4. If you have additional transmitters (up to 4) that need to be programmed, repeat step 3 for each
transmitter.
Exit: Turn Ignition to 'OFF' position, or leave it for 15 seconds. 3 long chirps & 3 parking light flashes will
confirm transmitter programming exit.
B. FEATURES PROGRAMMING:
FEATURE “
I
” PRORAMMING:
1. Turn the Ignition switch ‘ON/OFF’ 3 TIMES and stay in the OFF position.
2. Push the Valet switch 2 times and hold it on 2
nd
push until one chirp with a long chirp is heard. Then
release the valet switch. You are now in the Feature
‘I’ programming mode.
3. Press and release the transmitter button ‘A’ corresponding to the feature ‘A’ you want to change.
a. The siren chirps and LED pause will indicate previously setting.
b. The system would advance to [2] LED flash, [2] chirp. (The factory default settings are always [1] LED
flash, [1] chirp.)
4. Depress the transmitter button ‘A’ again to change the feature again. Simple keep re-depressing the
transmitter button ‘A’ again until the module advances to your desired setting.
5. Depress the transmitter button ‘B’ corresponding to the feature ‘B’ you want to program.
Press
Transmitter
Button
One Chirp /
One LED Pulse
Factory Default
Setting
Two Chirps /
Two LED Pulses
Three Chirps /
Three LED Pulses
Four Chirps /
Four LED Pulses
1
All Chirps off
All Chirps on
Siren Chirps on only
Horn Chirps on only
Exit: Turn Ignition to the 'ON' position, or leave it for 15 seconds. 3 long chirps will confirm exit.