Moeller Z-FW-LP Installation Instructions Manual - page 2
2/8
Spannungsversorgung
LED grün Betriebszustand
LED rot Alarm
Funktionswahlschalter
Relaisausgang Alarm
Betätigungshebel
Sperrhebel
Koppelstecker
Relaisausgang FI-Auslöseprüfung
Eingang Ein, Aus/Reset
Eingang Test
Tension d’alimentation
Essai de d
PFIM/PFGM
DEL verte service
DEL rouge alarme
Sélecteur de fonctions
Sortie à relais d’alarme
Levier de commande
Levier d’arrêt
Raccord
éclenchement sortie à relais
Entrée Marche, Arrêt/Reset
Entrée test
Power supply
LED green Operational
LED red Alarm
Function selector switch
Relay output for Alarm
Link
Actuating lever
Blocking lever
Relay output for RCD tripping test
On input, Off/Reset
Test input
Napájení
LED zelená, Provoz
LED ervená, Porucha
Voli funkce
Reléový výstup pro signalizaci poruchy
Propojka
Páka pro ovládání pipojeného zaízení
Reléový výstup pro vypínací modul proudových chráni
Vstupy ZAP, VYP/RESET
Testovací vstup
Páka pro blokování funkce
Alimentazione di tensione
LED verde stato di funzionamento
LED rosso allarme
Selettore di funzione
Uscita relè allarme
Leva di comando
Leva di blocco
Relè d’uscita PFIM - Prova di sgancio
Ingresso/On, Reset/Off
Prova d’ingresso
Tensi n de alimentaci
ó
ón
LED verde Estado de service
LED jojo Alarma
Selector de funciones
Salida de relé Alarma
Palanca de accionamiento
Palanca de enclavamiento
Salida de relé PFIM - Prueba de disparo
Entrada Cierra, Apertura/Rearme
Entrada Prueba
Achtung!
Bei Unterbrechung der Versorgungsspannung speichert Z-FW...
letzten Zustand und nimmt diesen nach Spannungsrückkehr wieder ein.
Z-FW...
Z-FW... schaltet nicht unmittelbar nach einem Befehl.
Z-FW...
nie ohne angebauten PLSM bzw. PFIM betreiben.
Ferngesteuertes Schalten mit Z-FW-MO ist möglich, außer in OFF.
Der Sperrhebel
verhindert in
Position unerwartete Schaltvorgänge.
Warnschild sichtbar beim
anbringen.
Die Freiauslösung eines PFIM lässt ein sehr kurzes Wiedereinschalten der
Netzspannung bei bestehenden Fehlern zu, deshalb Personenschutz beachten.
Ein vorgeschalteter Überspannungsschutz der Klasse C muss in der
Verbraucheranlage vorhanden sein.
Attention!
In the event of the power supply being interrupted the
saves the
last operating state and retains this state when the power supply is
restored.
Z-FW...
Never operate the
without the PLSM
fitted.
Remote switching is possible in all operating modes except in OFF.
The blocking lever
in the
position prevents unintentional switching.
Provide a suitable warning plate in a visible location on the
The tripping of an PFIM allows the mains supply to be switched back on
momentarily in the event of a fault. Therefore ensure suitable measures for the
protection of persons.
A class C surge arrester connected upstream must be provided in the load
installation.
Z-FW...
or PFIM
The Z-FW... does not switch directly after a command.
Z-FW...
AUTOM
5x
AUTOM
5x
OFF/RESET
OFF/RESET
Z-FW-LP
Z-FW-LPD
+
+
+
+
13
14
7
8
9
10
7
8
9
10
7
8
9
10
7
8
9
10
Z-FW-LPD
U1-U2
48 V=
13-14
5 A/250 V~
Z-FW-LP
U1-U2
220 - 240 V~, 50Hz
13-14
5 A/250 V~
7
8
9
10
7
8
9
10
Z-FW-MO
P1 P2
400V~ max.
ON-C-OFF 24 - 240 V AC DC
T1 T2
24 - 240 V AC DC
8
9
10
ON
ON
OFF/RESET
OFF/RESET
Z-FW-MO
8
9
10
6
4
2
5
3
7
GB
D