N-Com B4 User Instructions - page 14
14
11.
AUDIO DEVICES WITH CABLE CONNECTION
The range of N-Com products offers various “Multimedia Wire” accessories for connection to
external audio devices: MP3 players, i-Pods, Satellite navigators, GMRS and PMR radio and
audio systems pre-fitted on motorcycles (MCS).
To find out about all the available cables, please visit the website www.n-com.it in the “Cable
connection compatibility” section.
Note: Connect the 3.5-mm 4-pole connector of the Multimedia wire to the helmet and the
other end to the audio device. A coloured band on the cable indicates the connector to be
hooked up to the audio device
Once it is turned on, cable connection stays active even in the subsequent menus.
Consequently, you can hear the device connected via cable even while listening to music via
A2DP or via RADIO.
12.
RIDER-PASSENGER INTERCOM MODE
In order to use B4
B4
B4
B4 in wireless intercom mode, both helmets have to be equipped with a
Bluetooth kit.
In order for two Bluetooth Kits to communicate with one another, they have to be paired up
first.
12.1.
Intercom affiliation
1.
Make sure both N-Com Bluetooth systems are turned off;
2.
Set both N-Com Bluetooth systems in Pairing up mode by pressing “on” (for more than 4
seconds), until the LEDS start to flash quickly;
3.
On either one of the two helmets, press “on” briefly;
4.
After a few seconds, the helmets “recognize” each another, a beep is emitted to signal the
pair up was successful and intercom communication is activated;
5.
Turn off both N-Com Bluetooth systems and turn them back on to store the pair up data.
12.2.
Intercom function
After carrying out the proper pair up procedure, turn on the two helmets. Intercom connection
will be established automatically (this will take a few seconds. Wait until you hear the acoustic
signal confirming the operation).
If automatic connection is not possible, proceed with the manual connection.
Manual intercom activation
With B4
B4
B4
B4 turned on, briefly press “on”.
Manual intercom deactivation With B4
B4
B4
B4 turned on, briefly press “on”.
13.
BIKE-TO-BIKE INTERCOM
The N-Com B4
B4
B4
B4 system is used for bike-to-bike communication up to a distance of about 800
m (open terrain, no obstacles).
N.B.: The range and quality of the communication may very significantly depending on the
presence of obstacles, weather conditions, magnetic fields.
N.B.: N-Com Bluetooth systems other than the B4
B4
B4
B4 do not allow this feature if not with
considerably shorter ranges.
The B4
B4
B4
B4 system stores up to 4 different B4
B4
B4
B4 systems, so that “calls” can be made to these
devices.
So that two B4
B4
B4
B4 systems can communicate with one another in the Bike-to-Bike mode, they
must be paired up first.