N-Com multi 3 User Instructions - page 11
MULTI 3
11
4.2.
N-Com Wizard
“N-Com Wizard” is the PC application that can be used to manage and configure the
MULTI 3 system.
The programme can be downloaded from the Internet site www.n-com.it, in the “Download” section. In
order to use it, a helmet equipped with MULTI 3 must be connected to the PC, using the USB cable
supplied with the system.
N-Com Wizard allows you to customize your MULTI 3, specifically:
Setting the system audio levels
Pre-set and manage your favourite radio stations
Update the device firmware
Turn on or off the Bike-to-Bike menu
Manage connections with other bikes
The programme includes an on-line guide that explains how it works (after installing it on your PC, press
F1 to display this guide).
Warning: FIRST, insert the jack connector into the helmet. THEN the USB connector into the PC.
4.3.
N-Com App
The N-Com system is pre-set for connection to the “N-Com App”, the Android application
used to configure and control the N-Com system directly from a Smartphone.
With the N-Com App, you can carry out most of the functions included in the N-Com Wizard program or,
alternatively, it can be used as a wireless Bluetooth keypad.
The N-Com APP can be downloaded free of charge from Google Play.
For additional details, please visit the website
www.n-com.it
5.
PAIRING UP BLUETOOTH DEVICES
In order for the MULTI 3 system to be connected to another Bluetooth device, the latter needs to be first
paired up with the N-Com system.
The pairing up procedure is the same for all Bluetooth devices: mobile phones, MP3 Bluetooth players,
satellite navigators, etc.
1.
Make sure the MULTI 3 is turned off;
2.
Press “on” and keep it pressed (for more than 4 seconds), until the LEDs start to flash quickly
and you hear a sharp beep in the headset, indicating the “Pair-up mode”;
3.
On the Bluetooth device, turn on the search for Bluetooth devices (refer to the instructions
manual of your device for the proper pairing up procedure, as it varies depending on the
brand and model of the device);
4.
After a few seconds, the mobile phone will display the name “N-Com Bt3 v.X.XX”, followed by
the manufacturer’s identification data;
5.
Select the N-Com device. If a password is requested, enter 0000 (four zeros);
6.
MULTI 3 will confirm the pairing up by means of a tone in the headset, and the LEDs will stop
flashing;
7.
Turn off and on both the mobile phone and the MULTI 3 to store the pairing up data.