N-Com multi 3 User Instructions - page 16
16
13.1.
Bike-to-Bike pair up
1.
Make sure both N-Com systems are turned off;
2.
Set both N-Com systems in Pairing up mode by pressing “on” (for more than 4 seconds), until
the LEDS start to flash quickly;
3.
On Helmet 1 press the “memory” button where you wish to store Helmet 2;
Position
Button
Confirmation beep
A
2 sec.
2 acute beeps
B
2 sec.
2 grave beeps
C
4 sec.
4 acute beeps
D
4 sec.
4 grave beeps
N.B.: If the selected memory setting is taken, you will hear an error beep after which a different
combination must be entered.
4.
After a few seconds, the helmets “recognize” one another: a confirmation beep is given in
Helmet 2 that indicates the memory setting where Helmet 1 is stored and Intercom
communication is established;
N.B.: if all the memory settings are free, Helmet 2 will store Helmet 1 in position A (see diagram in
Chapter 13.1). In case that setting is taken, the following one will be selected according to the
sequence listed in the table.
You can display the memory settings of your device (and check the names of the
paired up devices) using the “N-Com Wizard” programme for PC or through the
“App N-Com” for Smartphone Android.
To make it easier to recognize the N-Com systems paired up in “Bike-to-Bike” mode,
you can rename them using the “N-Com Wizard”.
13.2.
Making a Bike-to-Bike call
To make a call to another bike that has been previously paired up, go to the Bike-to-Bike menu and
press the button assigned to the helmet to which you want to make the call.
The corresponding tone will be heard in your helmet, after which the call to the selected helmet is made.
N.B.: In case the memory setting is empty, or the other helmet cannot be reached, an error tone will
sound in your helmet.
13.3.
Taking a Bike-to-Bike call
Four calling tones will sound in the helmet receiving the Bike-to-Bike call, and all open audio functions
will be temporarily cut off (including the Rider – Pillion Passenger intercom, if any). The call can be
answered by briefly pressing any key when you hear the ringtone signal.
In case you take the call, communication is automatically established. In case the call is not answered,
the system returns to the situation prior to receiving the call.
N.B.: you can cut off Bike-to-Bike communication from anywhere in the menu by briefly pressing “on”.