Nacecare RM1800H Use And Maintenance Manual - page 4
4
Preparation for work
To prepare the machine for work, do the following operations:
1.
Connect the spray gun to the spray hose and the spray hose to the quick disconnect
coupling located on the rear of the machine.
2.
Connect the vacuum hose to the rear of the recovery tank.
3.
Connect the floor wand to the solution and vacuum hose.
4.
Put some fresh water into the solution tank. Put only water, without chemical. Use clean
buckets only.
5.
Insert the chemical bottle in the holder and connect the cap. Check that the chemical
bottle is well connected to the chemical cap.
6.
Connect the plug of the machine to a proper electrical socket, provided of grounding.
Read carefully the instructions in the safety regulation paragraph.