Nacecare RM1800H Use And Maintenance Manual - page 7
7
Maintenance
Observe the following advice to obtain a perfect working and a long life of your machine:
1. After use, ensure the recovery tank is drained and cleaned with clean water only
2. Leave the recovery dome off when storing the machine to prevent moisture damage to the
vacuum motor
3. Check the clean water filter in the soluton tank on a weekly basis to ensure there is no
damage to the mesh filter
If the machine will be stored for a period longer than 1 week, please follow this procedure:
1. Plug the machine in to the wall
2. Connect the spray hose and gun to the machine
3. Disconnect the chemical cap from the chemical jug
4. Get a small bucket of clean water
5. Puth the chemical cap into the bucket of clean water
6. Turn the selector knob to the 1 droplet position
7. Turn the pump on and spray the gun
8. Continue this for 10 seconds
This procedure clears out any residual chemical left in the system. If not cleaned, the residual
chemical will harden and potentially plug the lines in the system.