Nacecare RM1800H Use And Maintenance Manual - page 5
5
STEP A
– PRE-SPRAYING CHEMICAL
1.
Ensure the chemical bottle is connected and has ample chemical
2.
Turn the selector knob on the rear panel to the 1 droplet position
3.
Ensure the spray gun is in the "High" position by pulling back on the nozzle
4.
Turn the pump on and allow 10 seconds for the chemical to prime through the hose
5.
Spray the area to be cleaned ensuring good coverage over the entire surface
6.
Allow the chemical to dwell on the wall for at least 2-3 minutes
7.
For very soiled spots, use the included deck brush to agitate and scrub the surface
RINSING THE SURFACE
1.
Ensure the defoamer bottle is in place and has an ample amount of defoamer
2.
Turn the selector knob on the rear panel to the 2 droplet position
3.
Ensure the spray gun is in the "High" position by pulling back on the nozzle
4.
Turn the pump on and allow 10 seconds for the chemical to purge from the hose
5.
Rinse the area thouroughly ensuring all chemical is removed from the surface
6.
Remove water from any mirrors with the included squeegee
7.
If there is no floor drain present, you may use either the wand for the triangular floor
tool to pick up the water from the floor
8.
If a floor drain is present, use the floor wand to pick up any residual water