NAD C 368 Owner's Manual - Amp
IR LEARNING DEVICE
IR Learning Device enables any non-NAD remote control learn AMP and BluOS
basic remote control codes. With the learned codes, the configured non-NAD
remote control can now be used to command or operate the C 368.
HOW TO LEARN REMOTE CONTROL CODES
1 Go to IR Learning Device menu. Select either AMP or BLS.
2 Select AMP and the first Amp Learning Key appears – VOLUME UP.
3 Press ENTER to select VOLUME UP and initiate learning mode.
4 Direct or point the non-NAD remote control to the IR sensor in the
front panel. Then, press desired button on the non-NAD remote
control where VOLUME UP will be learned. Upon pressing the
designated button, display will turn to “Learned”.
5 “VOLUME UP” is now learned into the designated button. Repeat
the same for the other codes to be learned. The same procedure
applies for BLS learning.
FIRMWARE VERSION
Display Main (MCU), VFD (display) and BT (Bluetooth) firmware versions.
FIRMWARE UPGRADE
Select Firmware Upgrade to initiate VFD Upgrade or BT Upgrade. At each
upgrade mode, select “Yes” to start upgrade process or “No” to retain current
firmware.
MDC CARD UPGRADE
MDC CARD UPGRADE identifies and shows the MDC modules installed at
the MDC slots in the rear panel.
OPERATION
OTHER FEATURES
IR Learning Device
Settings
Source Setup
AMP
Settings
MDC Card Upgrade
Settings
Source Setup
Slot:2 BluOS
Settings
Amp Learning Key
Settings
Source Setup
VOLUME UP
Settings
VOLUME UP
Settings
Source Setup
Learning...
Settings
VOLUME UP
Settings
Source Setup
Learned
Settings
Firmware Version
Main:V1.39
VFD :V1.13
BT :V1.13
Settings
Source Setup
Settings
Firmware Upgrade
Settings
Source Setup
VFD Upgrade
Settings
15
ENGLISH
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
РУ
ССКИЙ