NAD C 368 Owner's Manual - -20.0 Db
BLUETOOTH AS A SOURCE
Initiate pairing of your Bluetooth device with the C 368 by following below
procedure.
1 Ensure that the Bluetooth antenna is connected to the BT antenna
terminal at the rear panel.
2 Select “Bluetooth” as the Source. Display shows “Discoverable”. Using
your iOS or Android device, go to Settings – Bluetooth and then scan
for Bluetooth devices.
At “Discoverable” mode, the unique device ID of your C 368 is listed or
selectable in the device list of your Bluetooth settings. Pair or connect
your C 368 and Bluetooth device.
Upon successful pairing of your Bluetooth device and the C 368, display
will change to “Connected” and then “Playing” when music is played
from your Bluetooth device.
OTHER BLUETOOTH SETTINGS
1 If you turn OFF the Bluetooth connection (not “unpair” or disconnect)
of your Bluetooth device, the display will change to “Connectable”.
When you turn ON again your Bluetooth device, the display remains
“Connectable”.
“Connectable” means only the same or current Bluetooth device can
connect to your C 368. This prevents other Bluetooth devices from
connecting to your C 368 unless current Bluetooth device is unpaired
or disconnected.
2 From the device list of the current Bluetooth device, select again the
unique device ID of your C 368 and connection will be resumed again
(Connected) and playback can be resumed also.
3 Now, for other devices to connect to your C 368 even if current
Bluetooth device is not unpaired or disconnected, press and hold
Standby button until the display changes from “Connectable” to
“Discoverable”. Any Bluetooth device can then select and connect/pair
to the unique device ID of your C 368.
IMPORTANT NOTE
If the optional MDC BluOS module is installed, Bluetooth as Source will
be defeated or not selectable. Use the Bluetooth option included in the
MDC BluOS module.
BLUOS SETUP
“BluOS Setup” becomes available as one of the Main menu items when an
optional MDC BluOS module is installed in one of the MDC slots in the rear
panel. The following are the BluOS Setup menu options.
IMPORTANT NOTE
The BluOS Setup menu options can be configured only at BluOS source
mode. With other sources, the BluOS Setup menu options can be viewed
only but not configurable.
INFO
Display MAC address, IP address, BluOS version and other related
information about the installed MDC BluOS module.
BluOS REBOOT
Yes: Restart MDC BluOS module.
No: Maintain current settings.
SERVICE MENU
There are two options for Service Menu – BluOS Upgrade and BluOS
Service.
BluOS Upgrade
Ensure that the MDC BluOS is connected wired or wirelessly.
Yes: Initiate BluOS upgrade mode. Upgrade mode will proceed
automatically.
No: Maintain current settings.
BluOS Service
Use for servicing purposes only. This is a feature normally associated
and coordinated with authorized service personnel.
Yes: Activate Service mode. This must be coordinated or
performed by authorized service personnel.
No: Maintain current settings.
BluOS RESET
Initiate the restoration of the MDC BluOS to its factory default settings.
Yes: Initiate factory reset.
No: Maintain current settings.
OPERATION
OTHER FEATURES
Settings
BluOS Setup
Source Setup
BluOs
-20.0 dB
Bluetooth
Discoverable
Settings
Source Setup
Bluetooth
Connectable
Settings
Source Setup
16
ENGLISH
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
РУ
ССКИЙ