NAD C356BEE Owner's Manual - page 10
A MC
INPUT: Input for a Moving Coil phono cartridge. Connect the twin
RCA lead from your turntable to this input if you are using a Moving Coil
cartridge.
B MC-MM
SWITCH: Slide this switch to either MM (Moving Magnet) or
MC (Moving Coil) depending upon the Phono cartridge being used.
C PHONO GROUND CONNECTOR: Turntables normally includes a single
wire earth lead. Use the C 356BEE Phono ground connector to connect
this lead. Unscrew the terminal to expose the hole, which will accept
the lead. After insertion, tighten the terminal to secure the lead.
D MM
INPUT: Input for a Moving Magnet Phono cartridge. Connect
the twin RCA lead from your turntable to this input if you are using a
Moving Magnet cartridge.
IDENTIFICATION OF CONTROLS
REAR PANEL
A
B
C
D
19 MDC CLASSIC UPGRADE SLOT: Remove cover to install the
optional Modular Design Construction (MDC) module. An example
of a C 356BEE-compatible MDC Classic module is the PP 375 Phono
Preamplifier module. The PP 375 is integrated into the chassis of the
C 356BEE, automatically assigned to the DISC input and its level well
matched to the other sets of line level input.
Consult with your NAD dealer on how to procure the PP 375 and
its consequent installation to the C 356BEE. Check out also the NAD
website for any announcement about future release(s) of other
C 356BEE-compatible MDC Classic modules.
With the optional PP 375 installed, refer below for descriptions of key
PP 375 parts.
10
ENGLISH
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
РУ
ССКИЙ