NAD C356BEE Owner's Manual - page 14
CONDITION
POSSIBLE CAUSES
POSSIBLE SOLUTIONS
No sound.
• Mains power cord unplugged or power not
switched ON.
• Check if mains power cord is plugged in and
power switched ON.
• TAPE MONITOR selected.
• De-select TAPE MONITOR mode.
• Mute on.
• Switch off Mute.
• Rear PRE OUT/MAIN IN amp links not fitted.
• Fit links.
No sound one channel.
• Balance control not centered.
• Center Balance control.
• Speaker not properly connected or damaged.
• Check connections and speakers.
• Input lead disconnected or damaged.
• Check leads and connections.
No audio despite the presence of an active
input at DISC rear panel input terminals.
• DISC input is disabled due to an installed
MDC module at the MDC Classic Upgrade
slot.
• Uninstall the MDC module from the MDC
Classic Upgrade slot.
No audio despite the presence of an active
input at MP rear panel input terminals.
• An external Media Player is connected to the
front MP socket.
• Unplug the Media Player connected to the
front MP socket.
Weak bass/diffused stereo image.
• Speakers wired out of phase.
• Check connections to all speakers in the
system.
C 356BEE does not respond to remote
control commands.
• Battery flat or incorrectly inserted.
• Check or replace battery. Follow correct
battery insertion setup.
• Infrared receiver (IR) window of the C 356BEE
or IR transmitter of the remote control is
obstructed.
• Check IR windows and ensure clear line-of-
sight from remote control to C 356BEE.
• IR receiver in direct sun or very bright
ambient light.
• Place unit away from direct sun, reduce
amount of ambient light.
Standby LED turns red during operation.
• C 356BEE has overheated.
• Shut down C 356BEE by turning off the rear
panel POWER switch. Ensure that there is
adequate space below, above and to the
sides of the C 356BEE to allow proper air flow.
After C 356BEE has cooled down, turn back
ON. Restart again the C 356BEE by switching
ON the rear panel POWER switch and then
pressing the front panel STANDBY button or
remote control’s [ON] button.
• Overall impedance of loudspeakers too low.
• Ensure the overall loudspeaker impedance is
not below 4 ohms.
REFERENCE
TROUBLESHOOTING
14
ENGLISH
POR
TUGUÊS
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
РУ
ССКИЙ