NAD T 187 Owner's Manual - page 44

The T 187 has the capability to operate via Alternate IR channel.  This is 

practically useful if you have two NAD products that can be operated by 

similar remote control commands. With alternate IR Channel, two different 

NAD products can be controlled independently in the same zone by 

setting each one to a different IR channel.

IR CHANNEL ASSIGNMENT

The T 187 and the HTR 8 remote control must be set to the same channel. 

To change the Main Zone IR Channel on the T 187

t Press and hold [ a SOURCE ] and then toggle STANDBY button to select 

desired IR Channel – the VFD will show “IR Channel 1” or “IR Channel 0”.  

The default IR Channel is “IR Channel 0”.

To change the IR Channel on the HTR 8 remote control

t Include a channel number before the library code. For HTR 8, library 

code “10” is the default library table for “AMP” device.  To select this “AMP” 

library table for “IR Channel 0”, retain the library code “10” (or “010”). 

t If you want to load the “AMP” library table on “IR Channel 1”, prefix the 

library code with “1” to indicate association with “IR Channel 1”.  Load 

then the “AMP” library table using the code “110”.

SAMPLE SETUP OF TWO NAD PRODUCTS ON THE SAME ZONE

NAD T 187 and NAD C 326BEE are both defaulted to IR Channel 0.  If [OFF] 

button is pressed on the HTR 8 remote control (or SR 8 remote control for 

the C 326BEE), both products will go to standby mode. Press [ON] and both 

products will power up from standby mode.

To prevent both products from simultaneously going in and out of standby 

mode along with other common commands, set each one to a different 

IR channel. In this setup, we will keep C 326BEE and SR 8 remote control 

defaulted to “IR Channel 0”.  As for T 187, we will assign it to “IR Channel 1”; 

the same applies to HTR 8.

Set T 187 and HTR 8 to “IR Channel 1” via the following procedure.

T 187

t Press and hold [ a SOURCE ] and then toggle STANDBY button to 

select “IR Channel 1”.

HTR 8

Begin by ensuring that the T 187 is powered-up (“on”, not merely in 

standby). 

t To enter HTR 8’s library mode, press and hold both the [AMP] device 

and [A/V PSET] until the LEARN LED turns green.

t While keeping the HTR 8 pointed towards the T 187, enter the 

library code “1100”. Press [OFF]. If the T 187 goes to standby mode, 

press [ENTER] to accept the library code number and exit library 

mode.  

With both T 187 and HTR 8 set to “IR Channel 1”, the C 326BEE can now be 

remotely controlled independent of the T 187.

NOTE

Performing a Factory Reset for T 187 or HTR 8 will result to a return to the 

factory default “IR Channel 0” setting.

OPERATION

USING IR CHANNEL

44

ENGLISH

FR

ANÇ

AIS

ESP

AÑOL

IT

ALIANO

DEUT

SCH

NEDERL

ANDS

SVENSK

A

Р

У

С

СКИЙ