Nady Systems 4W-1KU Owner's manual - page 11
11
HT-1KU Handheld
Microphone Transmitter
Buttons Function
The RF Power level Switch (27) is used to
select Hi/Low power transmission.
Each time the Set Button (26) is pressed, the
LCD menu will cycle in the following order:
MAIN MENU
>
VOLUME
>
GROUP
>
CHANNEL
>
MAIN MENU
(repeats)
The (Up) or (Down) Buttons (25) work in
the set mode only. They can be used to
change any Group/Channel as selected
(if not using IR Sync from receiver).
They can also be used to select the desired
Input audio level VOL setting. Or they can
be used to turn on the LCD display.
During manual programming, the selected
function will flash for five seconds, or press
the Set button to confirm the selection and
the display will return to the main menu.
Setting up the Transmitter
The HT-1KU requires two AA size batteries
to operate. To install the batteries onto
the battery compartment, unscrew the
Battery Compartment Cover (22) by turning
counterclockwise until loose and slide down
the cover, exposing the Battery Compartment
(35). Insert two fresh aa batteries (36)
according to the correct polarity as indicated
on the transmitter body. Screw the battery
cover back onto the microphone, making
sure it is securely tightened. Fresh alkaline
batteries can provide up to 8-10 hours of
operation, but in order to ensure optimal
performance it is recommended that the
batteries be replaced after 6-8 hours of
use or as indicated to be necessary by
the flashing Battery “BaTT” Meter Icon (33).
Powering the Transmitter On/Off
To turn on the transmitter, slide the Power
On/Off Switch (28) to the “ON” position. The
LCD backlight will light up, indicating the unit
is now on. After ten seconds the backlight
will automatically turn off to conserve battery
life. The Group (30), Channel (31), Input Volume
level (32), and Battery Meter (33) indicator icons
stay on for normal operation.
As many of the LCD battery meter levels
should stay lit as possible, as they indicate
usable battery strength. As the batteries
weaken, fewer of the level indicators will
stay lit until only one bar shows, which will
then flash to warn that the batteries are now
too low and should be replaced as soon as
possible with fresh ones.
To preserve battery life, turn the transmitter off
when not in use. To turn the transmitter off,
slide the power on/off switch to the “OFF”
position. The LCD will display “OFF,” no LCD
or backlight is lit up and the unit will be off.
At Power Off the transmitter will store the last
settings entered and re-display them at the
next power on where it can be reprogrammed
to any new Group/Channel or Volume level
at the first time of use or anytime later.
The factory default setting for Volume -10dB
is same for all transmitters. These settings are
optimal for most applications.
Programming the HT-1KU
to the Selected Channel
The transmitter can be programmed to the
same frequency as selected for the receiver,
either via automatic synchronization using
the IR Sync function or manually on the
transmitter itself.
IR Sync Programming:
Use the wireless IR leD Receptor Sensor (34)
to download pre-programmed channels
from the receiver. Start programming by
holding the IR Receptor Sensor/Window