Nady Systems PAS-250 Owner's Manual - Installation & Operation

4

INSTALLATION & OPERATION

Please read  this manual thoroughly before using.

INSPECTION

Your MaxTower was carefully packed at the factory in packaging designed to 

protect  the unit in shipment. Before installing and using your unit, carefully 

examine the packaging and all contents for any signs of physical damage 

that may have occurred in transit.

CONTENTS

• Instruction manual 

• MaxTower PAS-250 (verify unit’s serial number is same as shown on       

    shipping carton) 

• AC power cord 

• Tripod speaker stand 

• Nylon carrying bag

SETTING UP

The MaxTower and stand fit securely in the supplied padded bag. 

 • Open the bag and remove the stand.  

 • Loosen the knobs, set up the stand, select height. 

 • Insert the metal pin through the stand. 

 • Tighten the knobs to secure. 

 • Remove MaxTower from the padded bag. 

 • Place MaxTower on stand securely through bottom mounting hole. 

 • Plug the AC power cord into the rear panel jack (11), then power cord  

     into a nearby power outlet. The MaxTower has  an internal power        

     supply and is designed to operate from an external AC source  (Power  

     Range: AC l00~240V, 50/6OHz (+/— 10%). Make sure  that the unit is  

     turned off before connecting to the AC power source to avoid possible  

     loud transients that can damage your speakers or your ears, especially  

     when monitoring with headphones. 

• Turn on unit with Power ON/OFF Switch (13) on rear panel.  The     

    Power On LED (1) will light.  

• Plug in mic or instrument, make any necessary adjustments, setting             

   channel gain, EQ, and reverb.