NAG SNR-CI-M Series User Manual - Snr-Ci-M Series
SNR-CI-M Series
Network IP Cameras User Manual
10
RIGHT, enter into edit by OPEN button and exit edit by CLOSE button.
Operations under edit state can be seen later.
2.6.5
SET PATROL: to edit data for multi-points patrol. Select no. of patrol by PAN
LEFT/PAN RIGHT, enter into edit by OPEN button and exit edit by CLOSE
button. Operations under edit state can be seen later.
2.6.6
RUN PATROL: to run multi-points patrol function. Select no. of patrol by
PAN LEFT/PAN RIGHT, run and exit by OPEN button.
2.6.7
RECORD PATTERN:
This pattern can consist of any standard pan and tilt or
lens command. Presets, flip, digital zoom, proportional pan, and turbo are not
allowed in a pattern. The pattern length is
40 seconds in maximum. To return
when 40 seconds expire or by push CLOSE button.
2.6.8
RUN PATTERN: to self-learn loci of tour. To exit the menu after running or
to stop running by joystick.
2.6.9
RETURN: return to Main Menu.
3.
Appendix to the Menu
3.1
Operation of Edit State of Multi-Points Patrol. When entering into edit state
the screen displays as follows:
NO – serial No. of patrol position
POS – No. of preset position
SP – leaving speed
TM – dwelling time
After entering into edit area, screen shows as
follows:
Edit Area, data of 2 patrol position appears
on one line.
SEQ:01 – It means the set No.1
patrol
CLOSE:EXIT – Push CLOSE to exit edit
state
Both top and bottom lines display prompt and information of each patrol is
displayed on the middle of the screen. Data of 2 Patrol points appears on one
line. Move cursor by PAN LEFT/RIGHT and modify data by TILT UP/DOWN.
Press buttons for one second to speed up operation. Press CLOSE button to exit
edit state and store modifications. The program will search the position of the
first “---” of POS, store dada before it and regard data after it as invalid. In
above figure, the program stores previous four points with settable range from 1
to 63 and from 65 to 128. When “---” of POS appears, the tour range is ended.
The settable range of SP is from 0 to 8 (0 and 1 are the same with fastest speed
while 8 has the lowest speed). The settable range of TM is from 0 to 99 seconds.
3.2 Operation of Title of Preset Point in Edit State. When entering into edit state
the screen displays as follows:
In the figure we find the preset point is No.1
with title of “NO TITLE”. Move cursor by PAN
LEFT/RIGHT and modify data by TILT
UP/DOWN. Press buttons for one second to