NAG SNR-CI-M Series User Manual - Snr-Ci-M Series
SNR-CI-M Series
Network IP Cameras User Manual
7
DISPLAY of the camera is ON)
a.
Description of the Focus Control Mode: the user can adjust the focus of the
camera manually. When the camera is on near focus, the icon
appears on
the screen; when on the nearest state, the icon
appears while on the far
focus, the icon
appears.
b.
Description of Backlight Compensation: when the object to be shot is dark
and looks dim, the user can open the backlight compensation according to
actual need and the icon
appears on the screen.
c.
Description of White Balance: when the image has color distort on the
screen, the user can set different modes by orders. There are 6modes for
options: ① Indoor Mode
② Outdoor Mode
③ Touch Mode
④Automatic Trace of White Balance ATW ⑤ Manual WB-MAN
⑥
Automatic Mode.
d.
Description of ZOOM Control: user can “pull near” or “push far” the lens
according to actual conditions, and the symbol
appears on
the screen in which the front part means optical multiplication while the rear
part means digital multiplication.
e.
Description of Electronic Shutter: it is fixed on 1/50 sec after initialization
when the camera is switched on, and the digital 50 appears on the screen.
f.
Setup of Image Effect: the camera works on OFF state under normal
condition and no image effect symbol appears on the screen. When “B&W”
appears on the screen, it means the camera is on black and white state.
g.
AE Mode: setup of Manual/Automatic.
h. Zero Illuminance: It is used only when the external brightness is extremely
low. Normally the camera works on the automatic state. In case the external
brightness is lower than 1Lux, the camera can be switch to the Zero
Illuminance state automatically and icon
appears on the screen. You
can also set the Zero Illuminance state manually.
III. Setup of the Menu of the Dome Camera
1.
Basic Operation of the Menu(
(
(
(Encl: Software manual
Encl: Software manual
Encl: Software manual
Encl: Software manual)
)
)
)
1.1
The main menu will be opened, when Call Preset 64 or Call Preset 1 twice in 4 minutes.
1.2
When the menu is displayed on the screen, operate “UP”, “DOWN” to move the
cursor to the option to be set, operate “LEFT”, “RIGHT” to modify the content
or the order to enter this option.
1.3
Keep the joystick in one direction for over 1 second to speed up operation.
1.4
All setups on the menu couldn’t be lost even power failure happens.
1.5
Special utilizations can be seen on the descriptions of functions of the menu in
detail.
2.
Setup of the Menu
2.1
MAIN MENU