Nanoxia Deep Silence 6 Revision B Manual - page 15
The bracket offers mounting holes both for 120 and 140 mm fans; install the fans, then attach
the bracket with the four screws back to the HDD-cage, as can be seen in the picture.
If you install case fans in the mounting bracket, those should support the movement of air
from front to back.
5.4 Fans in the side panel
If you want to accommodate
fans in the side panel, remove
the outer cover by loosening
the screws on the inside.
The dust filters can remain in
its position. Please place the
fans on the inside of the side
panel above the dust filter
and screw them in from the
outside.
If you secure the cover in the side panel again after the removal of a side fan, please make
sure not to tighten the screws not too much. To avoid damage to the internal thread or the
side panel, the screws should be tightened by hand only.
5.5 Fans at the case bottom
You can install two additional
120 or one 140 mm fans on
the bottom of the case. It
may be necessary to remove
the additional 3- bay HDD
cage screwed to the bottom
(
see chapter 3.3
)
120 mm
/
140 mm
120 mm
/
140 mm
EN
13
14