1 using your xp-600 security system napco © napco 2005 oi301 1/05.
2 introduction congratulations on your purchase of an advanced napco express xp-600 security system. Meticulously developed by a leading manufacturer of state-of-the-art security products, this system will provide you with unprecedented peace-of-mind and incorporates some of the most sophisticated f...
3 introduction system information central station phone number: ____________________ central station account number: ____________________ for service call: ____________________ entry delay: ____________________ exit delay: ____________________ alarm time-out: ____________________ table of contents k...
4 keypad controls and indicators * key used to enable special functions and options. Press * and then the corresponding special function num- ber option (see special functions, page 11) bypass key used to bypass zones. Press bypass and the corre- sponding zone number, and then arm system. Numerical ...
5 arming your system when leaving 1 before arming your system, make sure the green x ready light is on. This indicates that all of your protective zones are secure. If any zones are open, the corresponding zone light will be on. Secure these zones before proceeding. If any zones cannot be secured, s...
6 protecting yourself while at home 1 before arming your system, make sure the green x ready light is on. This indicates that all of your protective zones are secure. If any zones are open, the corresponding zone light will be on. Secure those zones before proceeding. 2 enter your user code. The gre...
7 emergency buttons the three sets of emergency buttons, if programmed, are always active whether the system is armed or disarmed. Discuss these buttons with your installer. The emergency signal will only be activated when the two respective buttons are pressed at the same time. Fire alarm: simultan...
8 disarming your system when returning 1 enter your premises through the entry/exit door. The keypad will sound a steady tone to remind you to dis- arm the system before your entry delay time expires. 2 enter your user code. The red w armed light will go out, indicating that the system has been disa...
9 preparing a fire escape plan even with the most advanced fire alarm system, adequate protection requires an escape plan. To prepare your plan, draw floor plans of your building (space is provided on the next page). Show two exits - a front or back door and a win- dow from each room. (make sure eac...
10 fire protection floor plan draw a plan of your premises below..
11 special functions a by pressing a followed by the appropriate key, (do not press simultaneously) these special functions and features can be enabled: a 0 easy arm (when system is disarmed) the easy arm feature allows the system to be armed by pressing a followed by 0 . This will allow the easy ar...
12 the xp-600 is constantly monitoring its own components, as well as all critical services, such as ac power and the telephone line, to insure that it is always ready to provide the protection for which it was designed. When a system trouble does occur, it will caution you by lighting the yellow h ...
13 h system troubles keypad beeps or h system flashes zone light on system trouble condition action 2 beeps 2 fire trouble a problem has been detected in the fire circuit. Call installing company for service. 2 beeps 3 wireless receiver trouble a problem has been detected with the wireless receiver....
14 your installer has assigned a user 1 code which may be used to not only arm and disarm the system, but also to enter the user program mode, where you can program other user codes. The following explains how you will use this code to program or erase additional user codes. Entering the user progra...
15 ambush code - in the event that you are forced by an intruder to disarm your system, this special code can be used to disarm the system, and simultaneously send a silent alarm to central station. If your system has the ambush feature en- abled, the code assigned as the user 6 code will function a...
16 napco limited warranty the following statement is required by the fcc . This equipment generates and uses radio-frequency energy and, if not installed and used properly, that is, in strict accordance with the manufacturer's instructions, may cause interference to radio and television reception. I...
