NAPCO GEM-P400 Installation Instructions Manual - page 9
9
Full Setting the System with Automatic
Bypassing - Home/Away with Delay
Zones
From the Keypad
Press
to return protection to
Home/Away with Delay Zones that have
been automatically bypassed. Three min-
utes are allowed to walk through
Exit/Entry
and
Exit/Entry Follower Zones.
Using A Keyfob (GEM-KF)
All zones in the system can be armed re-
gardless of the state of the
Exit/Entry Zone
when arming with a Keyfob and using an
AUX key programmed as
Full Set. Press
and press and hold the
or
keys
for 1.5s when leaving the premises. All
zones, including
Home/Away Zones are
armed.
Bypassing a zone
Press the
key, then the zone number to be
bypassed. While the panel is DISARMED, the
bypassed zone LED will flash slowly; indicating
the zone has been bypassed. While the panel is
ARMED, the bypassed zones will only be dis-
played if the
Display Bypassed [21-3] option
has been selected.
Unbypassing a zone (Disarmed
only)
Press the
key then the number of the
zone to be unbypassed.
Group Bypass
Press the
key to Bypass all
Exit/Entry
Follower Zones [02] or Home/Away Zones
[01] (only if the system is programmed
exclusively for
Home/Away with Delay
zones).
Using A Keyfob (GEM-KF)
Hold the
or
key on the Keyfob to
Bypass all
Exit/Entry Follower Zones [02]
or
Home/Away Zones [01] (only if the sys-
tem is programmed exclusively for
Home/
Away with Delay zones).
8VHU 3URJUDP 0RGH
To prevent the loss of the User 1 Code, the panel
default program includes
User 1 Code Lockout
[96-2]. To change the User 1 Code from its
default value of 1234, program the 4-digit User 1
Code through Dealer Programming [95]. User 1
Arm/Disarm code is also used to program User
Codes 2 - 8. By default, the User 1 code cannot
be re-programmed by the user.
If it is necessary to change the User 1 code, it
can be changed through downloading or Dealer
keypad programming. From Dealer Program
Mode, change the U
ser 1 Code Lockout ([96-2]
LED=OFF) to disabled.
Entering User Program Mode
1. Enter
2. Enter User 1 Code (
)
(Default)
3. Press
ARMED
,
STATUS AND
SYSTEM TROUBLE
LED’s
WILL FLASH
.
ARM
ED
G E M I N I
STA
TUS
1
A 1 is displayed indicating
User 1 Code is programmed
and 2-4 are blank.
Wi879a
page 9
Tuesday, September 16, 1997 08:16