Napoleon SDO800 Installation Instructions And User Manual - page 10
8
Basic function setting and applying
1. Itinerary setting Opening & closing force self-learning
2. Matching the receiver and transmitter
Fig. A
Fig. B
Press
„SET‟ button and hold on until the LED displays
figure
„1‟, then adjust the up limit by pressing „LIM-1‟
button. Fine-
tuning „LIM-1‟(up) or „LIM-2‟(down) button
to determine the final up limit position then press „set‟
button the display turn into „2‟ automatically. Adjust the
down limit by pressing „LIM-2‟ button. Fine-tuning
„LIM-1‟(up) or „LIM-2‟(down) button to determine the
final down limit position then press „set‟ button. The
opener will operate a cycle automatically to remember
the limit positions and the opening & closing force.
Press „CODE‟ button and hold on until the LED dot is
on. (Fig. A) Then press any button on the transmitter
once, the dot will be off; press the button again the dot
will fast flash then LED displays
„11‟ (Fig. B). After that
the transmitter will be available.
Press „CODE‟ button more than 8 seconds until the LED
displays „C‟, all the stored codes will be deleted.